96 has 2 one in front. there is no bank2 on I-4 motors S1 is always the front sensor S2 is the rear (behind CAT)
Check this link http://carfix.stufftoread.com/find-parts.html
At the back of the engine, looks like a distributor!
there isn't one ( 96 it start that year) you only have a cam sensor in the base of the distributor.
try replacing the crankshaft position sensor
Locate the camshaft sensor in your car. Disconnect the electrical plug on the sensor. Remove the bolt that holds it in place. Twist the the sensor to remove it and place in the new one.
possible symptoms are the engine warning light will be on
service light poor fuel milage
if you disconnect the o2 sensor cable in the air intake then start the engine you would see the check engine sign turned on in the gauge panel. It is on then the sensor is working if off the the sensor may have problems
Bank 1 sensor 1 where is it located on the Suzuky swift 2005?
on the side if the tranny. its called the PRNDL switch. look for cig pack size black plastic and cable, bingo. that be it.
Bank 1 is cylinder 1 side of the motor. Sensor 2 is the back oxygen sensor (after the catalytic converter.
When you have a bad oxygen sensor your car may consume a lot of gas. Your car may also drive slower.
Most often it's an oxygen sensor, but it can also be plugs, wires, burned valves, vacuum leak, air filter or any of a number of problems. Connect a code scanner and see what the computer says, that can often be the best information.
you have one above or on the manifold and one under the car on the exhaust pipe
IAT's are located primarily connected through the air box, where you aor filter is, by the throttle body, by the intake manifold and is a 2 wire connector.
No, it will cause the after cat oxygen sensor to send an incorrect reading to the computer. Federal law prohibits their removal anyway.
price of camshaft sensor for a Suzuki baleno 1300cc
There are two oxygen sensor for Mitsubishi Outlander. Front Oxygen Sensor and Rear Oxygen Sensor
what year? what motor 8v or 16v the 8v has 1 , right on top of exh.manifold the older (pre 96) has 1 at the exhaust collector. the newer 96+ have 2 , but only the front one controls air fuel ratios. the rear sender is only a CATCONVerter monitor.
If the vehicle was built with an oxygen sensor, you will need an oxygen sensor.
where is the coolant temperature sensor on a suzuki xl7 2002
what are the symptoms of bad tdc o2 sensor
Bank one sensor one can be found on the drivers side before the cat. The best way to change the sensor on an '01 XL-7 is to buy an oxygen sensor tool, the socket model works best! These can be found at any auto parts store. I believe they are 22mm?
It's integrated into the oxygen sensor. Buy a new oxygen sensor and you get a free oxygen sensor heater.