A popping sound (when running if it will run), backfiring, and low compression on one cylinder when testing with a compression guage.
If you have a bent valve slide, or valve, or valve casing, they usually wont move. Valve's and valve casings would prevent the valves from moving, while bent valve slides wont easily pull out. If you suspect a bent valve, valve casing, or slide, try cleaning and oiling it first, valves and slides can become stuck with the lack of valve oil or slide grease.
the valve bent because the piston hit it, due to a weak valve spring or over revving the engine
check for bent or burnt valve check for bent or burnt valve
yes a bent valve will not seat properly. can also wear the valve slide and ruin the head.will also cause backfiring and loss of power. sometimes a bent valve will breakthen fall down and punch a hole thru the piston or the side of the cylander bore so yes a bent valve can cause further damage to your engine
IF there is no compression in one or more cylinder, you either have a bent valve, a burned valve or a bad head gasket. In any case, the head must be removed if you plan to repair the engine.
Broken valve spring, bent valve, rocker arm fell of, hole in piston, rings, etcBroken valve spring, bent valve, rocker arm fell of, hole in piston, rings, etc
no
on a 98 ford taurus what are the symptoms of a bad hydralic valve lifter
Do a compression test.
You don't fix it, you replace it. Replace the belt according to the schedule in your owner's manual. If it breaks and your engine is an interference engine, you will 95% of the time have damage. You will know the extent of the damage when the engine is torn down. ---------- Saturns do not have a timing belt, they have a chain, as stated in the question. Symptoms of bent valve will show on a leakdown test or engine simply will not run.
Probably a bent valve cover from overtightening Replace or try to straighten then tighten to 10 inch lbs. only
Sounds like the valves are not closing properly. Something in the valve train is damaged. Could be a bent or broken valve, broken valve spring, broken or bent rocker arm, bent push rod, etc. Low compression combined with back firing thru intake would indicate a damaged intake valve component and back firing thru the exhaust would indicate a damaged exhaust valve.