answersLogoWhite

0


Best Answer

I believe that is ( 6 degrees BTDC ) / automatic transmission in California 10 degrees

BTDC

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What are the timing specs for a 1975 2.3L mustang?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are the timing specs for a 96 Ranger 23L SOHC 4 cylinder and will the crankshaft position sensor cause it not to crank?

haha i asked this question and i can answer it now. I finally got my truck on the road !!


Where do you find overhaul information for a 2004 mazda-3 23L?

The dealer may be able to provide specs for you. Best to ask when it's not busy if they can print off what you need from their service computer.


What are the timing marks on a 92 Pontiac grand am with a 23l L ohc engine?

Pontiac grand am 92 year 2,3l ohc engine timing marks. Does anybody have piCture? Pontiac grand am 92 year 2,3l ohc engine timing marks. Does anybody have piCture?


What would cause your 96 ranger 23l to backfire through the breather?

More than likely it has jumped time. This is a comman problem with older timing belts. Or in colder weather.


Which measurements is equal to 2300 dL?

23l bro.


How may cups in 23 liters?

About 97.2 cups to 23L


How do you rebuild a 1988 ford ranger 23L engine with fuel injection?

Take it to jasper they rebuild any motor.


How many ounces are in 58 and 23 liters?

58L = 1,961.21 fl oz 23L = 777.723 fl oz


How much is 23l in millimeters?

A litre is a unit of capacity. A millimetre is a unit of distance. The two units are therefore incompatible.


Where is the EGR valve located on a 1996 Ford Ranger 2.3?

egr valve location on a 1997 ford ranger 23l


Is the neutral start switch the same thing as the neutral safety switch on a 1997 ford ranger 23l 4cly?

yes


93 Ranger 23L has poor acceleration and little power after having timing belt replaced could the pushrods have been bent when the belt snapped?

Run a compression test. If only one cylinder has low compression, it's probably a damaged valve or pushrod. If the compression is low in all cylinders the cam is probably not timed correctly.