0
What are the torque setting for crank pully bolt of opel corsa lite 1.4i?
Wiki User
∙ 7y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the crank sensor located on a 1993 3.1?
It is behind the crank pully!
What would cause a crank seal to leak on a 1990 Mitsubishi montero ls 3.0 liter v6 engine?
AnswerCheck the crank pully bolt. If it has come loose you will have a leak.The crank pully bolt does not have anything to do with the crank shaft seal leak. Thebolt is independent of the seal. To replace seal remove crank shaft pully and you will have access to crank shaft seal, pull out & replace seal.
Where is the crank shaft position sensor located on a 2000 Mitsubishi Eclipse?
behind the crank shaft pully and the timing cover and then another pully is there two bolt hold it on
Where is the crank sensor located on 1998 Bravada?
the crank sensor is located just behind the crank shaft pully of the engine.
How many engine belts on a 2003 Kia Sedona?
two. one around the crank pully, idle, ac and alternator and one in the back on the crank pully, and others for the engine
What is the torque settings for crankshaft pulley on a Honda Accord 2.3L engine?
which direction does a crank shaft pully bolt screw out on a 2002 honda accord lx 2.3l eng. clockwise or counterclockwise?
Where is a crank sensor located on a 2002 wrx?
Under the alternator above the crank pully. 10mm bolt.
Changing timing belt is the pully on the main crank threaded you have a puller on it and it wont budge?
No the crank does not have a thread as long asyou have taken out the bolt in the center of the pully it should move they can be very tight. try tapping round the edge of the pully as you apply pressure with the puller
Where is the Location of the crank position sensor for 1994 Corsica 3.1?
its locted by the crank pulley the ower pully on the car
Where is the Saturn 2000 l2 3.0 v6 crank position sensor located please help?
behind the crank pully
Where is the location of the crankshaft sensor on a d16y7?
Directly next to the crank pully on the block
How do you remove the crank shaft pulley on 1996 Geo metro 1.3l?
How do I remove a pully from the drive shaft. The snap ring that holds pully on has been taken off.Itried a gear puller but it bends the pully.
