0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Will my torque converter flex plate spacer plate and starter from my c4 fit an aod transmission?
your spacer plate and starter should be the same the flex plate and converter will need to be replaced
What is the torque sequence for a 1974 nova's flex plate?
Just criss-cross on the bolts and don't tighten them all in sequence, just like tightening lug nuts on a wheel.
What are the torque settings for flex plate bolts on a smallblock Chevy?
Crankshaft to flexplate: 50-60 lb-ft Flexplate to torque converter: 45 lb-ft Use Grade 8 or better at both locations.
What has to br done to replace a 99 gp flex plate?
The transmission has to be dropped first. then the torque convert/clutch needs to be removed to gain access to the flex plate, which can then be replaced.
What is a flex plate?
A flex plate is the flat piece of metal that connects the engine to the transmission's torque convert. Most have teeth around the edge for the starter to engage into when starting your car.
What is the flex plate on your 1997 Plymouth Breeze?
It is the ring gear and plate that conects your engine and automatic transmission's torque converter.
How do you replace a flex plate in a 2002 Pontiac grand prix?
The flex plate is bolted to the back of the crankshaft. It connects the motor to the torque converter in the transmission. To replace you remove the transmission and replace it.
Bad knock on engine people say flex plate on 1979 gmc 350 engine?
If it really IS the flex plate, that's a lot cheaper than other problems that could cause a bad knock. The flex plate is a steel plate that bolts to the rear of the engine and has gear teeth around it. The starter engages with the teeth to start the engine. The torque converter also bolts to the flex plate. All power produced by the engine that is used to move the vehicle goes through the flex plate. Flex plates get old and sometimes crack. When that happens you want to get the old flex plate out of there as soon as you can before it breaks completely and destroys the torque converter. A flex plate is relatively cheap, compared to a complete engine rebuild or replacing the torque converter. To replace the flex plate, simply pull the engine (or transmission, whichever is easiest), unbolt the flex plate from the crankshaft, bolt up a replacement and put the transmission (or engine) back. Of course, there is more involved than that, but it's not as bad as some repairs.
Do you torque the flex plate to convertor on c4 automatic transmission?
All fasteners have a torque spec suggested by the manufacturer. You will find that information in the shop manual for the vehicle.
How do you replace a flywheel on a 89 ford bronco II wautotrans?
Remove the inspection plate/dust cover from the bell housing. Disconnect the torque converter from the flex plate. Remove the drive shaft from the transmission. Separate the engine and transmission and support the transmission while you remove the flex plate. Replace the flex plate and put it all back together.
How do you remove a torque converter switch on a 2004 explorer?
how do you remove the tourque convetor botls to flex plate on a 2003 explorer
What is the purpose of the flex-plate on 350s with automatic trannys and can new crate motors use the old one even if they give a recommended part number?
The flex plate connects to the crankshaft and bolts to the torque converter. The flex plate also has a ring gear that meshes with the starter. If the flex plate is in good condition it can be re-used. Check the gear to make sure that none of the teeth are worn. If all teeth are still in good shape and there are no cracks in the flex plate it can be reused. very commonly found in older ford f250
