Hi,
Should be 30 nm and then tighten by 90 degrees in order and then another 90 degrees in order.
Double check on http://www.fiatforum.com/
Thanks,
Ben
Fiat do not issue torque settings for a punto they use angles so that you can snap your stretch bolts! after contacting fiat and haynes neither of them would give proper torque settings, so i delved into my many tech manuals on fiat fire engines which is what is in your punto and i have successfully changed many fiat punto head gaskets using the following torque settings: stage 1 starting from the centre head bolts tighten to 33nm: stage 2:65nm and finally stage 3: 96nm these torque settings work fine and will probably save you buying new head bolts.
Fiat do not issue torque settings for a punto they use angles so that you can snap your stretch bolts! after contacting fiat and haynes neither of them would give proper torque settings, so i delved into my many tech manuals on fiat fire engines which is what is in your punto and i have successfully changed many fiat punto head gaskets using the following torque settings: stage 1 starting from the centre head bolts tighten to 33nm: stage 2:65nm and finally stage 3: 96nm these torque settings work fine and will probably save you buying new head bolts.
Fiat Seicento was created in 1997.
The torque settings for a 96 Fiat Punto 12cc for cylinder head bolts are 30 NM at 90 degrees. Then an additional 90 degrees.?æ?æ
You have not told us for what bolt or nut ?. There will be almost a whole page of torque settings for that vehicle. Oilpan bolts may be as little as 12 while cylinder head bolts will be around 70 . We have no clue unless you name the bolt.
A fiat seicento Hawaii
Yes, they have two!
8-10Nm
The Italian Fiat Seicento was first introduced in late 1997. From around late 1997 to April 2004, over 1.1 million Fiat Seicentos were produced and sole.
There isn't a specific torque for the little 8v fire engine..and the head bolts need to be initially tightened to 30Nm and then a further 90 degrees twice over..remember also to use new bolts because the old ones will have stretched..
Q
30nm 90degrees and then another 90degrees