Haynes manual says 58 ft lbs. be sure that the bolt threads are all clean, and if there is any resistance from putting the bolt in the hole, tap it out. the bolt size is 12 mm, pitch is 1.25. Also, make sure that there is nothing in the bolt hole. the hole in the block has oil in it, the bolt can bottom out in that and give a false torque reading.
36 ft lbs and then 90 degrees
58 ft lb inner to outer clockwise staging...
torque for 2c engine cylinder head bolts
1991 toyota camry head bolts torque specs
The torque specs for a Toyota Camry cylinder head is 60 pounds for the inside bolts and 50 pounds for the site bolts. The cylinder head bolts should be tight from and to end alternating.
torque specifications
What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?
33 ft lbs and then 90 degrees then another 90 degrees in an x pattern
Step 1 - 20 NmStep 2 - 78 NmStep 3 - 90oStep 4 - 90o
The cylinder head on a Toyota Paseo requires 33 pounds of torque on the head bolts. If the bolts are over tighten the block can warp leading to a blown head gasket.
The torque specifications for the cylinder had, in your 2003 Kia 1.6 liter engine, is 120 pounds per square inch. The bolts should be torqued at 40 pound intervals.
Torque as follows 53-63 ft/lbs. in 3 steps