Want this question answered?
Disconnect the driveshaft at the rear end and pull it out of the trans.
8.1 nm
whats the torque spec for the pressure plate on a 1998 kia sportage?
$126 for the whole clutch kit. Clutch,pressure plate,and throwout bearing.
Cars use a single plate clutch as there is enough space to use the correct dia plate to create the right amount of torque, while motorbikes use multi-plate clutches because they have limited room and need to create more friction surfaces to produce the required torque.
The torque setting for the pressure plate on the clutch for an s10 2.2 is 33 foot pounds. The torque for the 4.3 is 29 foot pounds.
pressure plate to flywheel bolts - 15 to 24
For your 1992 Nissan/Datsun 300ZX: Flywheel Torque 61-69 Foot pounds (Final torque)
Takes about 19 hours all up to replace clutch plate pressure plate and thrust raceproviding you have access to a hoist.
19lbs ft
If a manual, bad clutch adjustment, worn clutch plate, worn pressure plate. If an automatic, bad torque converter. On either, check the parking brake.
replace your pressure plate (diaphragm type), and the clutch. replace your pressure plate (diaphragm type), and the clutch.