Want this question answered?
Front disc brake caliper bleeder screw: between 13-18 ft. lbs
The manual for the 2006 Dodge Ram 2500 states that the torque on the front brake calipers should be set at 250 foot pounds. A proper torquing tool should be used.
Brake caliper to carrier front & rear are both 22-32Nm
No need to rotate the front caliper pistons as you compress the front calipers. That process is only for the rear calipers because of the parking brake mechanism.
I don't have 2000 specs, but according to the 2004 Sienna Repair Manual the torque spec for the front brake caliper mounting bolts is 79 ft-lbs and the torque spec for the brake pad pins is 25 ft-lbs.
Lift the car on a car jack, remove the tire, remove the brake shoe/calipers, and remove the old brake pads. Next, dispose of the old brake pads, put in the new brake pads, replace the brake shoe/calipers, replace the tire and lower the car to the ground.
the tacoma has calipers on front.
The brake calipers can be the same the front calipers on turbo cars is normally bigger as up to 90% of your braking force is on the front brakes but the back ones are somtimes bigger not always
2003 SATURN L 300 front axle torque spec
The Helm factory service manual states that the front should be 118 pounds. The rear specs should be 89 pounds.
Could be cheap brake pads.
No