I was just trying to install the cover after a new gasket, checked the torque settings and they recommend at 25 pounds first following this sequence the second bolt from the left to be the first and the one below or directly on the other side to be the second. Third the one immediately to the right and fourth the one below it. Fifth on the left top corner and sixth below it, seventh to the top right and eight the one below on the right corner, ninth the center bolts and finally the tenth on the right middle. The second pass at 65 pounds, but here is what I intend to do following the same sequence, tight using one hand until it stops with a gentle pressure -10 pounds- then three times one quater of a turn at a time if you feel that it needs the fourth quater turn to complete the full 360 turn then do it but use your judgement and do not over tighten it. I snapped the first bolt trying to follow the 25 pound with a torque, need new bolts.
What do you torque the head bolts on a 1998 nissan altima 2.4 l
80ft lbs
what are you wanting to torque. There 100's of torques in a vehicle.
72 to 87 ft lbs.
It is 87ft. lbs. My owners manual for the Nissan Altima 2001 says exactly, "72 to 87 ft-lb (98 to 118 Nzm)."
if engine is 2.4 liter twin cam, torque is 2 steps. step 1 starts center out torque is 35 inch pnds. step 2 repeat center out 65 to 90 inch pnds. this is for valve cover pan .
12 to 14 ft. lbs in sequence
what are the torque specs and sequence for a 1992 Nissan maxima manifold
The Torque Spec and assuming you didn't change your rims, 72-87 ft. lbs Anyone who tells you 100, are ignorant.
20-25lbs.
The bolts have a number on it, what is the number? There is a general torque spec in the shop manual that will say what the torque is based on that number
what is the torque specs for a y d 25 2004 model nissan frontier main bearing and rods on engine