Want this question answered?
24 ft lbs lower intake 115 inch lbs exhaust
The 1995 Honda Odyssey exhaust manifold bolt torque specification is 45 pounds. The exhaust manifold bolts should be torqued in 15 pound intervals.
45 ft.lbs.
18 ft lbs
I suck! I suck!
Cylinder Head bolts 65 ft/lbs=Intake Manifold bolts 30 ft/lbs==Exhaust Manifold bolts 25 ft/lbs=
The torque settings for the exhaust manifold lower heater shield bolts for?æa d16y5 is 96 in - lbs. The oil pan drain plug torque settings is 29 and exhaust pipe to manifold nuts is 25.?æ
The exhaust manifold needs to have a gasket in place to help seal the juncture between the manifold and the engine. After the gasket and gasket sealer are in place, tighten the bolts for the exhaust manifold. The exhaust pipe can then be replaced on the new exhaust manifold.
Remove the intake manifold, exhaust manifold, and then remove the head. Scrap off the old gasket and install a new one. Reinstall the head and Torque the head bolts in the proper sequence. Reinstall the intake and exhaust manifold torque the bolts to the proper torque. This is a major repair and not for a novice to try.
25 NM25 NM
Remove the intake manifold, exhaust manifold, and then remove the head. Scrap off the old gasket and install a new one. Reinstall the head and Torque the head bolts in the proper sequence. Reinstall the intake and exhaust manifold torque the bolts to the proper torque. This is a major repair and not for a novice to try.
The only reference my manual has to exhaust manifold bolts says to tighten them and bend the locking tabs over.