answersLogoWhite
notificationBell

Top Answer
User Avatar
Wiki User
Answered 2012-03-04 17:23:51

Open the FOB and find out.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


Open the key fob and remove the battery which has a # on it, and then buy a duplicate.


Open it up and I am sure you will find just one and you will then know how many and the correct size to buy.


Open the key fob, remove the battery and look and see what size it is.


the key fob battery is the battey in a key fob torch


A small battery that fits in a key fob or remote.


That depends on the problem. If it's just a battery problem, replace the battery and follow the instructions on the inside of the fob. If the fob has failed, Saturn requires that you take it to a dealer to program the replacement fob.


please help remote fob has new battery but still will not lock or unclock my 2000 hrv


The battery size is CR2032. Pretty widely available at electronics stores


the battery is a 2032. and available at most good stores (eg tesco)



Hi, it takes 2 CR2025 batteries.



Usually the key FOB has a trunk latch, but if the battery runs out or you don't have a key FOB, check next to the drivers door, next to the gas release lever, there should be a trunk release lever.


Remove the valet key from the fob and behind it is a small Phillips screw. After that the fob will split and the battery is visible.


Open the key fob up and look see what battery it contains. Buy that exact battery.


If you know for sure that the alarm is functioning correctly, but the key-fob doesn't operate - either the fob is faulty or the battery is flat. Replace the battery - if the fob operates the alarm, then the battery was flat. If the alarm still doesn't operate, then the fob is faulty. You can always test the battery with a multimeter - although you may have to dismantle the remote to get at the battery !


what is the replacement battery for a 2003 Honda accord key fob


Changing the battery in the key fob to a Pontiac Solstice is pretty simple. Just remove the back of the key fob, and take out the old battery. It takes a hearing aid battery, and they can be found at any chain pharmacy. Put in the new battery and replace the back to the key fob. It is now ready to go!


You do not have to reset the key fob when changing the battery.


No, You do not need a key fob to start a car. When starting a car, you put the key in the ignition and turn. Power comes from car battery, not from the key fob battery!


According to the 2006 Ford Five Hundred Owner Guide : Each key fob takes ( 1 ) coin type three volt lithium battery ( CR2032 ) or equivalent


Changing a Mazda 2 battery in the key fob is quite simple. You will need to use a flat head screwdriver to pry open the fob. You will then take the battery out with the screwdriver and replace it.


I just changed the battery in my 2000 Corvette key fob. Use a coin to open the case being careful not to touch any circuitry because the static electricity could damage the FOB. Be careful when removing the battery and replace it (in my case) with a CR2450 battery. I found the battery at a CVS pharmacy. Replace the battery with the writing or plus side facing up. Then hold the FOB close to your car and hold down the lock and unlock buttons for 7 seconds and the car horn should beep. Good luck


The battery in the key fob of a Volvo v70 is changed by opening the case with a penny or nickel. The battery can then be taken out and a new battery slid into position.


The fob has a pry slot and prys apart.