Another 10 amp fuse. If you use anything larger, you can fry your equipment, cause a fire, and so on. If this fuse is blowing all the time, there is a short in the component or wire.
100amp
Yes, as long as the amp rating is the same. Examples, 600v 100amp fuse can be used in a 120v 100 amp's location.
100amp on a RCD
We have a 1995 Camry and the fuse box is located on the right handside if you stand in front of the car, you have to unscrew the bolts that hold the fuse box (its the one near the front of the car) and then turn if over you will find that the fuse has wires attached to it the same as the 100amp fuse in the front, then unscrew the bolts that hold the fuse in place and it should just come out by pulling on it. Hope this helps
No, use a fuse rated for the proper voltage.
Recheck the wiring around the fuel pump, or check your polarities on the battery. Something is shorting out!
You can replace it with a 100amp fuse if you want, but you have to remember why the fuse is there. It acts as protection in the event of a fault. Instead of the equipment being damaged by overcurrent, the fuse blows. If you put a higher rated fuse in, then in the event of a fault the chances are the equipment may be damaged (and possibly start a fire) before the fuse has a chance to blow.
The Fuse size is listed on the under side of the Fuse Cover.
To change the fuse in a Rover 200, locate the fuse box and the fuse needing changed. Use pliers, pull the fuse out gently and put the new one into place.
Any piece of machinery that is designed to use a fast blow fuse should only use a fast blow fuse. For safety reasons this could save your life instead of taking it.
the answer is if that happens u can check the 100amp (blue) alternator fuse next to the battery...
A two pole breaker protects both L1 and L2 legs. An over current on either leg will trip the breaker.