Using star delta method of wiring you can run high rated motor with out any high starting current. Star connection can provide 3 phase power as well as single phase load
One must check the design of the transformer windings. STAR - Delta or Star to star or Delta - star or Delta Delta. Wiring must be done accordingly.
i don't know please help
The Delta Star was created in 1983.
In motor starters, this is usually done using contactors. Explanation of this can easily be done using a circuit diagram. There are three contactors, the main, star and delta contactors-all these contactors can be the same type. There are many ways of wiring a star delta but here I will only give a generalized answer. First, the main contactor and star contactors are energised thus the motor runs in star. After about 5 seconds, the timer which gets energized at the same time as the main and star contactors, switches its CONTACTS i.e the normally open closes and the normally close opens. This dienergize the star contactor and energized the delta contactor. Thus, the motor now runs in delta.
hahahaa
A delta star is a mathematical technique to simplify the analysis of an electrical network, not a "real" star.A delta star is not a its a mathematical formulasee related link
A star-delta motor should be supplied star-delta.Wye is simply another name for star. Star-delta motors use a star or wye configuration to start, and a delta configuration to run. This reduces the voltage on the windings during the high current starting time.
The Star-Delta control circuit diagram shows the delta contact and the main contact.
it is the mathematical analysis which shows relationship b/w various resistors connected in star or delta form's using the transformation process we can convert delta into star or viceversa
In manual star delta starter, the change over from star to delta does not happen automatically. The operator or user puts on the starter, and after few seconds he pushes a lever or handle to change over to Delta. In automatic method, change over happens from star to delta using an automatic preset timer.
Star voltage is 1 / 1.732, or 0.577 delta voltage. (1.732 is the square root of 3.) It follows, then, that star current is 0.577 delta current.Not asked, but answered for completeness, star power is 0.5772, or 0.3333 delta power. This is why large motors use a star-delta start sequence - to minimize startup thermal stress.
Compared with what?