Has the fuel filter been changed? Also, if it still happens after the new filter, check the fuel pressure.
To the rear wheels.
To reset the low brake pad indicator on 2010 Ford Trans IT simply turn on the ignition and press the foot brake and the accelerator simultaneously. The accelerator and the foot brake should be pressed at the same time.
it may be the drive shaft u-joints if its rear wheel drive
What do you mean by "Skid"?
you would spin in a circle
The function of an accelerator in a car is to increase the speed of the car. When the accelerator is pressed, the car gains speed because an increased amount of fuel is added to the motor's consumption.
The 95 Saturn SL1 does it too.
Flat spots occur due to several reasons. It could be leaks in the accelerator pump piston or the accelerator pump valves. It can occur when you are accelerating because there is a momentary hesitation from the engine after the pedal is pressed down.
Engine chokes and loses power when accelerator is pressed
if it runs fine until you push the gas pedal the accelerator pump may be bad if it has a carb on it.
if I understand the question you asked correctly, I would say you are in need of a clutch but it might need adjustment but not likely.
Gravity and friction. You need to keep the accelerator pressed to compensate for loss in speed.