What can cause transmission fluid to come for the filler tube?

Why is the transmission malfunction light on in your 1992 BMW 325i?

There are several things that can cause your transmission malfunction light to come on. The most common cause is low transmission fluid.

Can low transmission fluid cause your car to putt and check engine light to come on?

It is possible.

Why does transmission fluid come out of dipstick?

The most common cause of fluid coming out of the dipstick tube is an over fill. Check the fluid level to see if there is too much.

Why does your Chevy Cobalt transmission slip?

The most common cause for transmission slip is low trans fluid level. The cobalt doesnt have a dipstick to check the fluid. You have to get under the car and while the engine is at normal operating temperature (AND STILL RUNNING) remove the transmission oil level plug that is located on the passenger side of the trans near where the CV axle enters the transmission. Pour fluid into the TOP of the transmission until fluid come out of the oil level plug hole. The filler hole for the transmission is marked by a red cap, just behind the oil filter canister (driver side of the engine compartment). The transmission automatically sets is fluid level using that hole. It sounds difficult, but its really not.

Does low transmission fluid make the 'check engine' light come on?

It would be one of the conditions that could cause this.

Why would transmission come out of the filler tube of a 2001 Ford Taurus?

According to the Chilton manual:"If the fluid level is too high, drain off the excess, then check the drained fluid for contamination by coolant. The presence of engine coolant in the automatic transaxle fluid indicates that a failure has occurred in the internal radiator walls that separate the coolant from the transmission fluid."Hope this helps.

Why does transmission fluid come out the dip stick?

The transmission fluid does not come out of the transmission dip stick. The transmission fluid is added through the dip stick area though. The exact specification on how to change transmission fluid will depend upon the exact vehicles and the owner's manual should be reviewed.

Would dirty transmission fluid cause engine light to come on?

Yes, the p0741 code and many other codes can sometimes be fixed when you flush the transmission.

How come a Transmission on a 1995 cavalier will not go into drive or reverse?

There are several things that can cause your 1995 Chevy Cavalier transmission not to go into drive or reverse. The most common cause is a lack of transmission fluid. A broken shifting fork will also cause the problem.

What is the cooling fluid that goes back to the transmission?

The 2 lines that come from the transmission and go to the radiator are full of transmission fluid and the radiator is what cools it.

How do check transmission fluid for 2005 Jaguar?

Transmission Fluid Level CheckSpecial Service ToolsCheckThe follow steps must be observed before starting the transmission fluid level check.The vehicle must be on a horizontal ramp.The parking brake must be applied.The engine must be running for 2 minutes with the transmission selector lever in the "P" position.Connect the Jaguar Approved Diagnostic System.Make sure the transmission selector lever is in the "P" position.NOTE: Make sure the transmission fluid temperature is below 30°C (86°F) on the Jaguar Approved Diagnostic System.With the engine running and the foot brake applied, circulate the transmission fluid by:Moving the transmission selector lever to the -R- positionWaiting for three seconds.Moving the transmission selector lever to the -D- positionWaiting for three seconds.Moving the transmission selector lever to the -P- positionRaise and support the vehicle.Remove the transmission undertray.Place a suitable container under the transmission fluid filler plug.WARNING: Make sure that care is exercised near rotating parts. Failure to follow this instruction may result in personal injury.With the engine running, using the special tool remove the transmission fluid fill plug.Remove and discard the transmission fluid fill plug.NOTE: Use transmission fluid meeting Jaguar specification.If the transmission fluid does not come out of the transmission fluid filler plug hole the transmission fluid level is insufficient. If this is the case add the transmission fluid in 0.5 liter units into the transmission fluid filler plug hole until fluid comes out.NOTE: Make sure the transmission fluid temperature does not exceed 50°C (122°F) . If the transmission fluid temperature does exceed 50°C (122°F) stop the transmission fluid level check and allow the transmission fluid to cool until the temperature is below 30°C (86°F) .Allow the transmission fluid to drain from the transmission fluid filler plug hole until the flow almost stops.NOTE: Install a new sealing washer.Using the special tool, install the new transmission fluid fill plug.CAUTION: Make sure the transmission fluid fill plug is tightened to the correct specification. Failure to follow this instruction may result in damage to the vehicle.Using the special tool and a torque wrench, tighten the transmission fluid fill plug.Tighten the transmission fluid fill plug to the torque given by the calculationTo make sure the transmission fill plug is torqued to the correct specification. Using the special tool and a torque wrench the following calculation steps must be followed. Step 1. Multiply 35 Nm by the effective length of the torque wrench (1).Step 2. Add the effective length of the special tool (2) to the effective length of the torque wrench (1).Step 3. Divide the total of step 1 by the total of step 2.Step 4. Set the torque wrench to the figure arrived at in step 3.Tighten the transmission fluid fill plug to the torque given by the calculation.Remove the special tool.Remove the container.Install the transmission undertray.Lower the vehicle.Disconnect the Jaguar Approved Diagnostic System.

98 ford expedition is it common to have a whining noise come from the transmission?

it has the wrong fluid in the transmission