0
What cause ice formation on suction lines of the compressor?
Rgvservices
The system and the load have become imbalanced. It will need to be looked at as the possible causes are many.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
If you have well water would a crack in the PVC pipes cause air in the pipes?
Any break or leak on the suction side of your pump can cause air in the lines.
Equalizing lines should be located in multiple condenser and compressor applications where Between condenser and evaporator coils or Near the TXV or Between compressors and condensers or None of them?
oppisite side of txv sensing bulb on outlet of evaporator (suction line)
What two copper lines connect the evaporator section with the condensing unit?
suction line liquid line
A short circuit in what is the most common cause of automobile fires?
The electrical wiring in a car can cause fires. However, the most serious fires in modern automobiles are caused by leaking fuel lines.
Four causes of faults on transmission lines?
Some cases I've seen: -Nature: -lightning strikes near line -fires (I've seen farmers burn weeds out from under a line - the fire ionizes the air, and with the added particulates in the air create a path to ground) -snow storms/icing on lines (can cause lines to sag) -high winds (can cause lines to blow out, possibly making contact with trees, or can cause enough stress to break poles). Winds can also blow stuff into the lines -tornados -Animals: -Two bears climbing a pole -Two owls fighting near a line -Eagle/other large birds swooping down between conductors -Eagle/other large bird pooping on conductors -People: -farmers touching power lines with harvesting equipment -crop dusters attempting to fly under lines -people crashing cars into poles
Where is low pressure AC port?
It will be on the suction line (larger of the lines) between the compressor and the evaporator.
What can cause ac compressor to start and stop?
Dirty condenser coils. Blocked suction lines. Low refrigerant charge. Incorrect suction line size. Too much refrigerant. Electrical problems. Contaminants in the system. Insufficient oil lubricant.
If you have well water would a crack in the PVC pipes cause air in the pipes?
Any break or leak on the suction side of your pump can cause air in the lines.
Is there a preferred location on the AC lines where the service charge ports should be located?
The low pressure port is usually close to the compressor, on the larger of the two lines, and on the suction side of the compressor. The high pressure port is the smaller of the two and could be anywhere inside the engine compartment but usually along the firewall. The location of the hoses and ports depends on where the compressor is mounted in relation to the AC unit inside the car.
What cause your 1988 Chevy truck not to blow heat at all replaced heater core and blen door actuator?
Have you checked your suction lines.
How do you replace the ac compressor in a ford f250 diesel?
Remove all A/C lines from the compressor which will cause you to lose you're R-12, release belt tensioner from the A/C compressor and remove the compressor from the engine bay and replace it with a new one. Installation is just reverse of removal
Equalizing lines should be located in multiple condenser and compressor applications where Between condenser and evaporator coils or Near the TXV or Between compressors and condensers or None of them?
oppisite side of txv sensing bulb on outlet of evaporator (suction line)
What would cause the AC compressor to stop turning on in your 1997 Blazer?
Check the clutch and see if it needs replaced; more then likely the compressor came apart on the inside and you'll have to replace it, flush the lines, and replace the orfice.
When is the low suction side of the ac system?
There are two coolant lines that come from the compressor. One line goes to the condenser (radiator looking thing in front of the engine radiator). That line is the High side. From the radiator, that line goes through the firewall. The OTHER line that goes to the comressor is the LOW side, or some call it the suction side. Somewhere along that line you should be able to find a refrigerant test port. The low side will only be low when the compressor is running.
How to replace 98 Buick Skylark ac compressor?
Remove the freon from the system. Disconnect the compressor belt, then remove the lines. Unbolt the compressor and remove it. Install the new compressor, connect the lines and belt. Pull a system vacuum, then fill with new freon.
Condensing unit wobbles?
A condensing unit should not wobble. If it does wobble, it can lead to issues such as broken lines. It could also cause the compressor to stop working.
Which port on AC compressor is low pressure 1999 Chevy blazer?
They may be marked "S" and "D" for suction (low side) and discharge (high side). A simpler way would be to look at the lines going into and out of the AC.... the smaller line will be the high pressure line, while the larger line will be the low pressure line. The low pressure line will connect at the compressor inlet, and the high pressure line will connect at the compressor outlet.
