answersLogoWhite

0


Best Answer

i would say its probably the security system. watch and see if the security light is flashing. if it is leave the key in the on position for ten minutes and watch the light when it goes out the vehicle should start.

User Avatar

Wiki User

โˆ™ 2008-04-24 14:28:57
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: What causes a 2000 Chevy blazer to run only 1 second and then stop Weak battery sensor other?
Write your answer...
Submit
Related questions

What sensor sits under the battery on a 2001 Chevy blazer 4.3l v6?

If it is yellow, it is for the air bags.


Were is the iat sensor on a 97 blazer?

iat sensor on a 97 blazer and what does it do


What is a crank sensor for a 1995 blazer?

A 1995 blazer does not have a crank sensor. SORRY


Location of the MAP sensor on a 1991 Chevy Blazer?

where the map sensor on 98 blazer?


Where is the crank position sensor for a 95 blazer?

Where is the crank position sensor hole on a 2003 Blazer


Where is the speed sensor on a 2002 blazer?

The 2002 Chevrolet blazer speed sensor is located on the side of the transmission. The speed sensor will be on the right hand side of the transmission.


Where are the oxygen sensors located on a 1996 blazer where is sensor 3 bank one?

I have a code DTC P0154.Bank 2 Sensor 1 no activity.Which sensor is this on my 96 Blazer?


Where is the IAT sensor on a 93 Chevy s10 blazer?

The 1993 Chevy S 10 Blazer IAT sensor can be found on the top of the transmission. The IAT sensor will be near the front of the transmission.


Does a 1994 Chevy Blazer have an IAT sensor?

NO.


Does a 95 Chevy Blazer have a crankshaft sensor?

That year did not use a crank sensor.


What would causes a 1994 s10 blazer to run rich?

It should set a code or two but, check the MAP sensor and the vacuum hose leading to it.


1996 Chevy blazer where is bank 1 Sensor 2?

The bank 1 sensor 2 on a 1996 Chevy Blazer is mounted in the exhaust. Sensor two is just behind the catalytic converter.


2002 Chevy Blazer Where is the O2 sensor for bank 2 sensor 1?

pass.side at exe manifold Bank 1 is where cylender 1 is. Bank 2 is on the other side of which is on the passenger side of the blazer. Oxygen sensor 1 is the first sensor closer to the front of the blazer. Sensor 2 would be past the catalytic converter on the same side.


Where is the O2 sensor located on a 2006 Blazer What is the color of this sensor?

where is the 02 censor located


Where is oxygen sensor bank one sensor THREE on 1997 Chevy blazer?

This would be the sensor after the catalytic converter.


Where is the AC sensor on a 1999 Chevy Blazer?

no such thing


Where is the camshaft sensor on blazer?

under the distributor cap


How do you test a crankshaft position sensor on a 1996 jimmy blazer?

To test a crankshaft position sensor on a 1996 Jimmy Blazer, use a CKP sensor to test for voltage output. Compare the results to manufacturer specifications.


What is sbs sensor?

sensor battery system


Were do you ground the temperature sensor for a 93 s10 blazer 4.3 vortech?

The 1993 Chevy S 10 Blazer 4.3 liter engine temperature sensor can be grounded to the engine block. You can use the temperature sensor retaining bolts to ground the temperature sensor.


Diagram of oxygen sensor to manifold on a Chevy blazer s10 and the entire exhaust system?

what is the wiring diagram for the o2 sensor on 2000 s10 blazer. it has 4 wires. what what do they all do /


Will disconnecting battery clear abs codes on 99 Chevy blazer?

you probably need to repalce one of the front wheel bearings(hub assembly). the sensor for the abs is located in the assembly


Where is the cam shaft sensor on a 2001 Chevy Blazer?

nic


Where is camshaft postioning sensor 1996 blazer?

its located in the distributor.


Where is the cam sensor located on a 1999 blazer?

inside the distributor