Hi, have same problem and answer is wheel cylinder is out of order and causes leaking. Need to change it, but better if you take car to garage and they change for you, because its very delicate work with springs and shoes, especialy if its your first time.
brake fluid leaking from a brake drum indicates the brake slave cylander on that wheel is leaking and needs to be replaced you will not see the actual leak with out removing the brake drum
They compress the brake fluid and push the brake shoes out against the brake drum stopping the vehicle.
The brake shoes are inside the drum, which is turning along with your wheel. When you press the pedal, it pushes fluid through the brake line, and that fluid forces the shoes outward and they push on the inside of the drum, which slows it down, and thus slows down your car.
You probably have a leaky wheel cylinder. Have the brakes inspect now!
IF you have rear wheel drive it may be a grease seal for the rear differential. Otherwise it is probably a wheel cylinder. Check your brake fluid level. GEt this fixed ASAP- Safety concern. Wheel cylinder, brake fluid.. If it's a rear wheel drive vehicle, it may be the axle seal leaking as well. Hello... hello...
The brake drum cannot fall off unless the wheel is removed. That is physically impossible.
Operates the brakes when the pedal is pressed. The pedal pushes the master cylinder, this pushes brake fluid down the brake lines, the fluid pushes the piston(s) in the wheel cylinder, the pistons push the pads or shoes onto the drum or rotor which is attached to the wheel.
If you're trying to remove the brake drum, be sure to NOT have the emergancy brake on. Remove the wheel and tap the drum with a rubber mallet until it releases, That's it!
Wheel cylinder (drum brakes) or caliber (disc brakes) sticking. If you find this to be the case you need to replace both sides and replace your brake fluid which is contaminated with moisture.
A piston on each end of the wheel cylinder pushes outward when the brakes are applied. This pushes the brake shoes against the brake drum and stops the vehicle. The pistons are forced out by the pressure of the brake fluid inside the wheel cylinder when you apply the brakes.
A piston on each end of the wheel cylinder pushes outward when the brakes are applied. This pushes the brake shoes against the brake drum and stops the vehicle. The pistons are forced out by the pressure of the brake fluid inside the wheel cylinder when you apply the brakes.
Sticking rear wheel cylinders. More than likely moisture in the brake fluid has caused them to rust. Replace the rear wheel cylinders and replace the brake fluid.