The airbag computer will command the airbag warning light to stay on when it detects a malfunction. You need to have the code read with a scan tool to know what the possible causes could be.
The airbag computer will command the airbag warning light to stay on when it detects a malfunction. You need to have the code read with a scan tool to know what the possible causes could be.
The airbag computer will command the airbag warning light to stay on when it detects a malfunction. You need to have the code read with a scan tool to know what the possible causes could be.
The airbag light stays on when the airbag computer detects a malfunction and sets a code. You need to have the system checked for codes to know possible causes.
The airbag light stays on when the computer has detected a malfunction and set a trouble code.
The airbag computer has detected a malfunction. You need to have the system checked for codes to know possible causes.
The airbag light stays on when the computer has detected a malfunction and set a code. You need to have the system checked for codes to know possible causes.
The airbag light stays on when the computer has detected a malfunction and set a code. The codes need checked with a scan tool to know possible causes.
It means that the airbag computer has detected a malfunction and set a code. The system will need checked with a scan tool to know possible causes.
The airbag light stays on when the computer has detected a malfunction and sets a trouble code. You need to have the system checked with a scan tool to know possible causes.
an electrical signal up to the airbag and it deploys
The horn switch is a contact between the airbag and the steering column. The switch is held or open up by 4 rubber "springs" or grommets. After time these grommets deteriorate and fail, causing the airbag side of the switch to contact the column side of the switch. This causes the horn to blow at any time the circuit is closed or "made". You can remove the airbag and disconnect the switch by pulling the slide terminal off of the connector, and taping the loose end of the wire. Or replace the 4 grommets that hold the airbag side of the switch up. Extreme care must must taken when removing the air bag assembly!
you need new tirods
You will need to have both computers checked for trouble codes, and then repair the causes of the codes to get the lights to go off.
get your airbag looked at it might need servicing