= How to check transmission and discover possible transmission problem when buying a used car. = Check Related Links Below
the gear shift might just go inside the tranny and shift the gears internally.
The gears in the tranny diff. Is shot. Is it a. A131l tranny. Thay have 2 place to fill. One in the middle of the tranny and the other on the back of the tranny. Where the cvc shafts go into the tranny by the rear motor mount.
Could be bad hydraulics? Possible it just wore out. or tranny fluid, tranny seal, clutch pads, tranny silinoid. autozone.com has an online q&a about autos, check it out
if you dont hit the clucth and do it you are just slaming it into gears or you are torking it to hard
The reason for the engine to shake and rattle when changing gears could be one of three things. 1. you just don't know how to drive and need to be more smooth when changing gears. 2. Your clutch may not be fully released thus you are just a bad driver. 3. your tranny is shot and a new one is recommended.
When you say jump, do you mean like thump or move or just shift hard or slam......... If it's been driven hard you may want to look at the tranny mounts or engine mounts. Ths will cause movement of the tranny when the torque is supplied and it may be hitting the frame if the mount is deteriorated
might be your wheel speed sensor for your speedometer but with the tranny jerking just use Valvoline high Mileage tranny oil changing it did the job for me
it should be located on the back passenger side of the tranny...mine just went and my bronco wont shift gears it stays in second... i plan on fixing it tomorow
The hold button just keeps the tranny in one particular gear. The transmission has other gears, so there is no need to force to use just one. Hope this helps you.
change your tranny pan trans filter its easy just ake sure totorc your bolts could be drive line or rear end too
n
it doent take transmission fluid unless your tranny has gears if it is just equipped with a cedntrifugal clutch no transmission fluid is needed.