0
600 cfm should be just right for a stock or slightly modified 350.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the best small block Chevy engine?
The 350 has, over time, been the best, most versatile, small block, ever.
Chevy small block run what temp?
180 is best.
Where can one purchase small block Chevy heads?
There are many places where one could purchase small block Chevy heads. Some of the best places to purchase small block Chevy heads at places like Amazon or Auto Zone.
What are the best small block Chevy heads?
for all out horsepower the splayed valve Chevy head, or the sb2 or 18 degree after that
What is the best gas engine ever?
Small-block Chevy The 454 Chevy big block offered much more available power but was horrible on fuel economy.
What is the best spark plug for a small block Chevy?
72-75 AC R44T 76-80 AC R45TS
How do you build a 358 Chevy engine?
Chevy 350 bored 60 over. .... not the best way to come to a 358... The "NASCAR" way is to use a 400sbc block and a 327sbc crank. High revving and big hp up top.
What is the best and easiest replacement V8 engine to put into a 1992 jeep wrangler yj?
I believe the Chevy small block is the best bet for ease of change over and thecheapest.
How can you tell a 350 small block from a 400 small block?
Go to search on your computer and type in small block Chevy engine ID and you should find your answer there.Most 350s id#end with 010,which is a early engine,and if heads are off there will be a small hole between the two center head bolt holes.But the best way is ID#s.Hope that helps.
What is the best car engine?
Chevy 327 Small Block, or Chevy 427 Big Block for horsepower, being bullet proof, very inexpensive, lasts a lifetime. Just really personal opinion really. :)
Where do you install the water temp sensor on a small block Chevy?
Best place is in one of the cylinder heads, by the spark plugs. Or, the intake manifold, near the thermostat housing.
Where is the best place to put the oil temp sender on a small block Chevy?
Most SB's from the late 1950's thru the mid 80's only had one location, on top of the block, right behind the intake manifold.
