Chevy Silverado
Ford Windstar GL
Ford Ranger XLT

What color are the wires that you need to remove on a 2001 Chevrolet Silverado to disable the door ajar warning?

293031

Top Answer
User Avatar
Wiki User
2005-11-25 05:25:54
2005-11-25 05:25:54

You need to take your vehicle to a dealership and hook it up to their diagnostics to turn that off; not a good idea to go cutting wires.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How do I remove the heatrest off of a 2000 LT Chevrolet Silverado

User Avatar

You will need to remove the speaker covers in your 2006 Chevrolet Silverado. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install the new speakers.

User Avatar

In 1995 there were not any carburators as everything is fuel injection.

User Avatar

Removing a 1991 Chevrolet Silverado door panel is pretty simple. All you will need to do is to remove the screws holding the door panel in place.

User Avatar

You will need to remove the dash and it should be somewhere under

User Avatar

You will have to remove the transmission. That is not a job for a novice. You need to take it to a repair shop and let them diagnosis and repair it.

User Avatar

Probably easiest way is to remove radiator first

User Avatar

You will need to go to a parts house and get the special tool that is required.

User Avatar

in the fuel tank you can either remove the tank or the bed to gain access.

User Avatar

It is bolted in the side of the engine block behind the starter. You will have to remove the starter.

User Avatar

Remove the keys and step away from the vehicle!

User Avatar

On top of the gas tank. To service/replace it, ya gotta remove the bed. Ick.

User Avatar

how i can remove or disable nawala progect

User Avatar

The easiest way to disable the security system on your 1987 Chevrolet Corvette is to remove the security system fuse. The security system fuse can be found in the fuse box.

User Avatar

Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter

User Avatar

There is 2 of them and thay are under the intake manifold. You will have to remove intake manifold to get to them.

User Avatar

There are two knock sensors on your engine, and they are underneath the intake manifold. You will have to remove the intake to get to the sensors.

User Avatar

It is bolted to the valve body in the bottom of the Transmission. Need to remove trans pan to service them.

User Avatar

You will have to remove the fuel pump relay or the fuse for the fuel pump. You did not say what year it was, so I can't tell you where it is. SORRY.

User Avatar

ac and heating fan control switch is needing replaced. I need to know how to remove and re install new one on a 2005 chevy silverado Z71.

User Avatar

It is mounted in the side of the engine block behind the starter. You must remove the starter to even see it.

User Avatar

Need to know year of Silverado


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.