Want this question answered?
To configure the clock rate for the hardware connections on serial interfaces such as network interface modules (NIMs) and interface processors to an acceptable bit rate, use the clock rate interface configuration command. Use the no form of this command to remove the clock rate if you change the interface from a DCE to a DTE device. Using the no form of this command on a DCE interface sets the clock rate to the hardware-dependent default value.
Clock rate must be set on an interface that is the DCE. This provides clocking for the DTE and helps with data transmission across the connection.
"time" command.
(1) Set clock command (2) Set data command (3) Set decimal command (4) Set device command (5) Set function command
The command is: clock rate 56000 So it will appear on the command line interface as: Router(config-if)# clock rate 56000 Reference: Networking by Jeffrey Beasley Chapter 6 page 216.
get out your owners manual and it will tell you how to do it.
What do you set the clock to on Nancy Drew and the Captive Curs i read all the books and it dint tell or i say to much but ill keep reading the last one to tell what it was :)
All you have to do is tell yourself what time you want to wake up and believe it will happen.
the clock is set for time
'how do I set the clock on a 2001 mercury mountaineer'
how do you set the clock on a 2001 oldismobile aurora
prompt