capacitor
enanu na una keta ne ena kekriya
That's a matter of opinion. Here's mine: The most important component of an electric circuit is the power supply. Because without it, no other component of the circuit does anything.
A circuit symbol is a symbol that represents a component in a circuit. For example a light bulb is a circle with a cross in it.
No, an ammeter should never be placed in parallel with a component - it should always be placed in series, so that the current through the component is measured.If you place an ammeter in parallel with a component, you create a short circuit around the component. Depending on the rest of the circuit, you could damage the circuit, damage the ammeter, create a fire, etc. You certainly will affect the current through the component, and that is not what you want to accomplish.
Clamping circuits use diodes and capacitors. First, the first circuit must be set up, then a?æsine wave should be input into it. The input and output should be observed and adjusted as necessary; then, the process should be repeated for the other circuits.
The current depends on the total effecvtive resistance of everything connectedacross the battery.If the resistor is the only component there, then the current is E/R = 12/3 = 4 amperes.
That a short to ground exists in the circuit.
Find it out yourslef
A blowing fuse is an indication that there is a short circuit condition in that circuit. A short circuit condition is the result of a "hot" wire or component in a circuit coming into contact with another wire or component which is "grounded." Grounded means that a metallic component is somewhere connected to the ground post [terminal] on the battery.
That a short to ground exists in the circuit.
Any circuit using a capacitor will not work if the cap is short-circuited.
Power source such as a battery if u pluged it in it will supply energy to drive electric charges around a circuit
It depends on what caused the device to not power on. The battery could be damaged. Replace the battery. The charging unit could be damaged. Replace the charging unit or find the damaged component and replace it. The charging connector could be damaged. Replace the circuit board or find the damaged component and replace it. The power button could be damaged. Replace the circuit board or find the damaged component and replace it. Something could have fried the circuit board. Replace the circuit board or find the damaged component and replace it.
No, it will run out just as much as if you put it in a series circuit. Parallel circuits involve the same voltage or amperage to go to each component.
A diode-clipping circuit is used to skip some portion of the signal (e.g. the half way/full way rectifiers rectify the '-ve' or '+ve' part of the signal). A diode-clamping circuit is used to add some signals to the original signal.
The purpose of the battery in a circuit is to wive energy to the circuit
Yes it does. A short circuited battery creates excessive heat from the rapid discharge. This heat damages the internal chemicals and component materials in the battery. In some cases can even cause explosions and fire.
A seríes circuit will not work when a component burns out, because then no current can pass around the circuit.