0
What can be done to fix a pantech breakout when it wont charge or turn on?
Wiki User
∙ 11y ago
It depends on what caused the device to not power on.
The battery could be damaged. Replace the battery.
The charging unit could be damaged. Replace the charging unit or find the damaged component and replace it.
The charging connector could be damaged. Replace the circuit board or find the damaged component and replace it.
The power button could be damaged. Replace the circuit board or find the damaged component and replace it.
Something could have fried the circuit board. Replace the circuit board or find the damaged component and replace it.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Is it possible to overclock a router?
Technically, a router can be flashed and custom programmed to run faster, and have higher wattage for WAN. I would not recommend doing this, as it may burn up your router and turn it into garbage if not done correctly. I have done this myself, and use it as a paperweight now. So the answer, YES it is possible but not recommended.
When you press the space bar it makes a instead of a blank space?
My Computer has done this before too. It means that your computer has been on for to long and is over heating, if you leave your computer on over night. Then what you should do is turn it off while you sleep, turn it off when you are not using it, and after downloading or adding things to your computer restart it. I hope I helped. =]
Does damage by esd permanently damages the computer?
Of course it does! To see static charges equalizing, turn off the lights in a room, scuff your feet on the carpet, and touch another person. Occasionally, you can see and feel the charge in your fingers. If you can feel the charge, you discharged at least 1,500 volts of static electricity. If you hear the discharge, you released at least 6,000 volts. If you see the discharge, you released at least 8,000 volts of ESD. A charge of only 10 volts can damage electronic components! You can touch a chip on an expansion card or motherboard, damage the chip with ESD, and never feel, hear, or see the discharge.
How do you turn off the speakerphone on a telus migo?
To turn off the speaker phone on a telus migo hold down the 1 button for 5 seconds. Do the same to turn it on.
Which way do you turn an alenkey to losen a scooter wheel?
Same as a screw, turn left to loosen and turn right to tighten. mnemonic. Lefty Loosie Righty Tightie.
How do you load music on a pantech hotshot?
yes the pantech hotshot does have a keyboard you just turn it sideways
How do you fix a pantech impact that will not turn on?
you get a new one!(:
How long does it take to charge a pantech swift?
It takes one hour - 45 minutes if you let it run out completely and if you turn it off completely it will be faster. However, if your battery comes out, it will only take 30 minutes to charge completly
Can you turn off auto capitalization on Pantech matrix?
nah son.
How do you use the Pantech pursuit front camera?
I dont believe, the pantech pursuit has a front camera. But it does have a back camera, you can just turn it around! I hope that helps!
How do you get a qwerty keyboard on the pantech hotshot?
All you have to do is turn your phone sideways with the screen facing tword you
How do you turn t9 on for the Pantech impact's external display?
No, you cannot. Why not use the full keyboard??
How to turn speaker on pantech phone?
During a call you have to press then middle circle button.
What do you do when your ds frezzes and it wont shut off?
you let it sit until it dies and then charge it then turn it on poof its done
How do you lower your vibration on your Pantech duo?
you can't lower the vibration just turn it on silent you crazy person......lol
What to do when your camera is dead and wont turn on or charge?
leave the camera so when you next turn it on and charge it, it will charge.
How do you get the back off the Pantech pursuit II?
turn it off. hold it face down. have the camera end down and you'll see a little slit above the upside-down "pantech" on the other end. slip something non-damaging in there and wiggle it. then it pops off.
