0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What components do you need to make a simple series circuit to light on bulb?
You need a Battery, Light Bulb, Ammeter, Switch.
What is the basic principle of fiber sensor?
A fiber optic sensor in general consists of a light source. The light source is coupled to an optical fiber. A light source which receives signal-carrying light beam on it emerges from the fiber. The signal from detector is processed electrically for getting information.
What are 3 electrical components used in a simple circuit?
A battery, a light bulb and a switch
What components do you need to make a simple series light bulb?
You need a Battery, Light Bulb, Ammeter, Switch.
How must the two transistor junction be biased proper transistor amplifier operation?
A: Actually it is only one transistor required for amplification the other junction can be a diode. As current Begin to flow it causes a bias across one junction which is opposite biasing for the other, A good differential amplifier will have those junction virtually at the same point with a very good current source because any mismatched will cause and output without any input. It is called voltage offset on the other end if the feedback current is very small it will also produce an output voltage offset known as current offset or basically errors
Which components of the eye contain the pigments the absorb light energy?
The corea
What components of the eye contain the pigments the absorb light energy?
Rods and cones contain the pigments that absorb light.
How do you make a light go on when voltage is low and off when voltage is high?
You can use a transistor in conjuction with other circuit components. Connect the signal you are monitoring to the gate of an n-channel mosfet, put the light in series with the drain and connect it to positive voltage, connect the source through a resistance to ground. Disclaimer: The above requires you to have a DC source to power the transistor from drain to source. Also, this assumes you are monitoring a DC voltage. If you are sensing AC, you'll need to convert to DC first using a rectifier circuit. Finally, this will not sense "just a little" voltage, since it will take some to turn on the transistor. If you need it to work through full range 0 - whatever max voltage is, you'll need to use a JFET or a more elaborate biasing circuit.
Is the whole galaxy a cell?
in theory it is because it has food source (earth) light source(sun and other suns) and all the other elements cells contain
What must happen in order for the photoelectric effect to occur?
A metal of a certain ionization potential.A light source that provides light of that exact energy potential.a circuit that has all the other components needed.
Is a traffic light a light reflector or light source?
light source
An object that gives out light is it a light source or it is a light energy?
It is a light source.
Is a computer screen a light source or a light reflector?
light source
What is a light source?
The Sun is a light source Something that makes light.
What are the ingredients for glowing gummy bears?
A glowing gummy contain a small LED (light emitting diode).The source of energy for the LED is a battery.
Is a lightning a source of light?
It is certainly a source of light but it is not a practical, usable source.
Why is candle a primary light source?
because its main source that gives it to light is one of the main source of light
