there is 4 resistors located under the instrament panel that usually need replaced or has a broken solder joint.
heres a video on how to fix it:
http://www.YouTube.com/watch?v=jTQIVS_uB4g
It is the mileage that is actually on the car. If the odometer is replaced, the correct reading is written down. Add that to the reading of the replacment odometer and you have the actual mileage on the car.
It is the odometer in kilometers, the first is in miles.
It is against the law to change an odometer meter please
The exact mileage per year is the odometer reading at the end of the year minus the odometer reading at the beginning of the year. If you don't have the odometer reading from the beginning of the year, the next best thing is to subtract an older odometer reading from the reading at the beginning of the year, then divide the difference by the number of years between readings. Without any odometer readings from the past, the best you can do is to calculate the average annual mileage over the life of the truck, which is the current odometer reading divided by the truck's years of service.
By driving the vehicle
This question is not answerable.
There isn't a separate computer for just the odometer. Attached to the firewall behind the coolant bottle is the main computer. There are 3 cables that plug into the front of the computer and the odometer is in there. When you buy a new or refurbished computer for your jeep you need the vin number and the odometer reading so the computer can be programmed for your jeep. Meaning the odometer reading is in the main computer
Check the owners manual. On the 2004 you follow this procedure. Shut the engine off with the odometer[mileage] showing. Turn the ignition switch to the run position [one position short of start]. Hold the trip selector button[the one sticking out of the speedometer lens]down for more than five seconds. The odometer will show 00000000.Release the button. The odometer reading will show. Turn the key off.
Shut the engine off with the odometer reading selected [the mileage]. Turn the key to the run position [one short of start] and hold the trip selector button sticking out of the speedometer lens down for more than five seconds. The reading will change to 0000000000.Release the button and mileage will show.
With odometer reading selected (not trip A or B) turn key to LOCK and remove key (not sure if this is necessary) insert key, hold down odometer button while you turn key to ON position. Continue to hold down odometer button. Odometer display will show ------ then blank, your Maintenance Required light will turn off and your old odometer reading will return.
Yes, absolutely
It's a scalar. It indicates distance but not direction.