vacuum leak?
If a car engine stalls when turning, there could be a problem with the power steering pump. There could also be an issue with an emissions control device.
One reason that a 2000 GMC Jimmy engine stalls while driving could be your filter needing to be changed. The problem could also be a bad sensor.
Does the (check engine )stay lit when you start from cold if not then check the engine oxygen sensor may need replacing or the turbo has been replaced and could be blowing out the spark
TCC Solenoid.
Could be faulty ignition coils especially if engine starts when cold then stalls and will not start once warmed up.
Headgasket is possible.
Have the same problem! Have you found a solution yet? I've come up with from searches that it could be Ignition Leads and or coil. Maf sensor or blocked cat
It is a common problem for shevy. Usually the Fuel regulator. Or for other vehicles it could be a dirty fuel filter
Try for a cheap fix and change your gas cap. Sounds like it could be vapour lock.
I experienced this same problem before too. The security system could be the problem. The imobaliser shuts of the car if it thinks there is a problem with the ignition(if it was hotwired).
Next time it stalls, have a can of starting fluid with you. Use the starting fluid and a helper to see if the engine will pop a couple times when it won't run otherwise. If the engine will run as long as you keep shooting brief bursts of starting fluid, then your camero has a fuel delivery problem... probably a clogged fuel filter, but not necessarily. It could be your distributor shorting out, or your spark plugs could be wet with gas. I had the same problem last year. Also, check your plug wires to make sure they aren't burnt or cracked which could cause arching.
It could have something to do with your oxygen/air flow sensor