0
What could cause a Left front popping noise in 98 Chevy blazer?
Wiki User
∙ 9y ago
A front popping on the left of a 98 Blazer could be the brakes, steering, or wheel bearing. Check all three to find the cause.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Will speed sensor on Chevy S10 blazer cause it not to shift into high gear?
Yes, it could.
What could cause theKnocking noise front of 2001 Chevy blazer?
low on oil, crankshaft and bearings bad
What will cause transmission leak in 1998 Chevy blazer?
Could be several reasons, need to know aprox where it is leaking from.
What would make a popping noise and make the blazer stop running?
When mine did that popping noise it was the fuel pump. But it could be a number of things. It depends on exactly what kind of popping. The Chevrolet Blazer wasn't the best of the bunch. They do really well as trucks. But the maintenance is that of a Toyota.
Why wouldn't a 1999 Chevy Blazer start?
Several problems can cause a 1999 Blazer not to start. There could be a fuel problem or a firing problem. Check for fuel pressure and ignition spark first.
What could cause a knocking noise from under the drivers side floor board on a Chevy Blazer?
Loose Lug nuts bad control arm...
Where can one buy Chevy Blazer parts in Houston?
One can buy Chevy Blazer part son Houston when one goes to the site Chevy+in+Houston. This site offers used Chevy as well as Chevy Blazer parts. Or one could go online to sites like Auto Trader.
How do you replace rear bearings in a 2002 Chevy blazer?
If you are here looking for the answer then you to invest in a chiltons repair manual for the vehicle cause it is a job that is or could be very complicated.
Where could one find maintenance tips for a 2000 Chevy Blazer?
There are many places where one could find maintenance tips for a 200 Chevy Blazer. One could check websites such as Fixya for information regarding maintenance on this vehicle.
Can low coolant cause no heat in 97 Chevy Blazer?
Yes it could and so could a stuck open thermostat or a plugged heater core or a faulty temperature blend door actuator.
What is the long round thing underneath your Chevy blazer in the middle?
Could be the driveshaft.
What would cause an 89 Chevy s10 blazer to miss when you press the gas?
Distributor cap, rotor, plug wires or spark plugs could do that. Time for a tune up.
