Possible plugged pump.
The error code E02 and F06 on a Maytag washer could mean that the hot water solenoid went out. It could also mean that that the hot water control is not working properly.
Most washers by Maytag are produced in Ohio. Could also be made in the Oklahoma are. But ALL Maytag appliances are 100% manufactured in the USA.
Debris in the hoses or reservoir could cause the motor to overheat. Also, running the pump without fluid could do the same.
Check the washer fluid pickup screen and/or pump.
You should first of all call the company that you bought the washer from. They might still have a warranty on your product, and then could send someone out to fix it for you.
If a washer pump was replaced on a Jeep Wrangler and is still not working the fuses should be checked. The washer switch should also be checked as it could also be causing the pump not to work.
My wiper blades have stopped working and the window washer isn't spraying out.
If a Maytag washer fills with water but does not agitate it could a problem with the switch in the lid. There is a switch that locks the lid down during agitation and spinning. The magnet could be defective.
There are multiple reasons why your washing machine might not drain. The drain line could be clogged with debris or even clothing, the pump pulley could be frozen, or the pipe that the washer drains into could be clogged.
There are a number of reasons why pipes might hum when they are turned on. A washer could be worn out and not working correctly. The fill valve on one of the toilets may not be working properly, or it could be your water pressure.
If it now works it could be a bad connection to the sprayers.
Several Reasons. Make sure that the hot water is turned on and flowing. remove and clean or replace any cone filters. try swapping the hot and cold lines and see if water will flow. Try giggling the selector switch. If it does not flow still, there could be a problem with the wiring inside the washer, the selector or timer switch may be malfunctioning or the valve assembly (the part where you hook the hoses up on the washer) may be broken or frozen. Have someone familiar with working with electricity check it out.