Hi,if you trawl through the other posts you will find many questions similar to yours.The engine icon is for "engine electronics",it means there is a fault or fault with a sensor,that is monitoring your systems.I maintain that the cheapest cure is to run the vehicle to a garage,not necessarily vauxhall,as long as they have the diagnostic kit.Phone up and ask.I use a local private garage. Most times it is a sensor problem rather than a component.For instance,my daughter's corsa started throwing in large amounts of petrol,making black smoke and choking to a stop at junctions.I guessed it was the coolant sensor but still had it confirmed on the computer.The sensor was telling the ECU that the engine was cold so it put in the extra fuel.
If it is a diesel engine it could be the glow plugs.
No, but something that could cause uneven idle could cause the check engine light to turn on.No, but something that could cause uneven idle could cause the check engine light to turn on.
Yes, just about any sensor on the engine could cause a no start.Yes, just about any sensor on the engine could cause a no start.
A vacuum leak could cause that.
If an engine was not assembled properly it could cause a low power complaint.If an engine was not assembled properly it could cause a low power complaint.
Anything that could cause a cylinder misfire can cause the check engine light to flash. A restricted fuel filter is one.Anything that could cause a cylinder misfire can cause the check engine light to flash. A restricted fuel filter is one.
Your engine might be the source of the problem, rather than the battery. However, only a mechanic could tell you for sure.
the engine
It could.It could.
could be alot of reasons for a check engine light, a sensor going bad, fuel cap not on tight enuff, bad fuel cap, missing, anything.. the only way to tell why it is on, is to check for engine codes on a computer hooked up to the car by a mechanic
A loose engine mount would not normally cause the engine to fall out because each car has several motor mounts. A loose mount could cause the motor to be off of balance.
hi dont know the answer to this but got the same fault any info would be good got 150 psi on 1 3 4 cylinders cylinder 2 is 30 psi eml on