0
a blinding concrete is a thin layer of lean concrete
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you calculate void ratio in concrete?
1) weight of cement in one cube divided by density of cement = volume of cement in a cube: 2) Similarly volume of fine & Coarse aggregate can be calculated 3) Adding all one will get volume of solids in a Cube-Vs: 4) Subtracting Vs from volume of cube Vc one would get volume of voids Vv 5) taking ratio of Vv to Vs one would get void ratio
Doubly reinforced concrete vs singly reinforced?
Doubly reinforced concrete and singly reinforced concrete are two types of reinforced concrete structures that differ in the way reinforcement is provided to resist tensile forces. Singly Reinforced Concrete: Singly reinforced concrete refers to a structural element (such as a beam or a slab) where reinforcement is provided only on one side to resist tensile forces. Typically, steel reinforcement in the form of bars or meshes is embedded in the concrete in the tension zone, where the concrete is subjected to tensile stresses. The reinforcement helps to carry the tensile forces, while the concrete primarily resists compressive forces. Singly reinforced concrete is commonly used in many structural applications. Doubly Reinforced Concrete: Doubly reinforced concrete refers to a structural element where reinforcement is provided on both sides to resist tensile forces in different zones. In addition to the primary reinforcement on the tension side, secondary reinforcement is also provided on the compression side to increase the structural strength and control the development of cracks. The secondary reinforcement helps balance the tensile and compressive forces, improving the overall performance and load-carrying capacity of the element. Doubly reinforced concrete is often used in situations where higher strength and resistance to cracking are required, such as in deep beams or heavily loaded structural members. The decision to use singly or doubly reinforced concrete depends on factors such as the structural requirements, loads, span lengths, and design considerations. Doubly reinforced concrete is typically employed in situations where the loads are higher or where there is a need to control deflection or cracking to a greater extent. It provides enhanced strength and ductility to the structural element. However, it also requires careful design and detailing to ensure proper placement and spacing of the reinforcement on both sides. It's important to note that the design and implementation of reinforced concrete structures should always be carried out by qualified structural engineers who consider the specific project requirements, local building codes, and safety factors.
What is the average markup for Cost Plus contracts for Design Build vs EPC projects?
The average markup for Cost Plus contracts for Design Build vs EPC projects is about $ 1200.
Is there a general rule for yield vs tensile strength in steel?
yield is the breaking point and tensile strength is what it is rated at per square inch
What is difference program vs schedule?
The programme refers to a masterplan divided up by tasks and durations. When a schedule is compared to the programme. The schedule referes to isolated / target plans with in the programme.
When was Broadzilla vs. the Tramp-o-Lean created?
Broadzilla vs. the Tramp-o-Lean was created in 1999-10.
What are the release dates for Turf War - 2010 Concrete Seating vs Concrete Jungle 2-3?
Turf War - 2010 Concrete Seating vs Concrete Jungle 2-3 was released on: USA: 25 April 2011 USA: 11 April 2011
How do you do a backflip on mx vs ATV unleashed on a PC?
on a PC just hold in shift and lean forward on the run up when you hit the middle of the jump lean back
How do you do a wheelie on mx vs ATV untamed for wii?
use the clutch at a dead stop then lean back and accelerate but don't lean back to far or you will topple over backwards
How many calories can you save by using 4 oz of lean ground turkey vs 4oz of ground beef?
100 calories
1 Explain the different types of research?
The basic types of research are as follows:• Descriptive vs. Analytical• Applied vs. Fundamental• Quantitative vs. Qualitative• Conceptual vs. Empirical
Semantic Features?
*CONCRETE (tangible, perceived by our sense) vs. ABSTRACT (not tangible, like concepts). *COMMON (names of objects that could be tangible or not) vs. PROPER (names of people, countries, rivers, mountains, etc.) *COUNTABLE vs. UNCOUNTABLE (like "freedom", cannot say 'two freedoms').
What are the archetypes in Siddhartha?
There are many different archetypes in Siddhartha -1 - Material vs. Spiritual2 - distractions [wealth] vs. focus[religion]3 - religion vs. wealth4 - pleasure vs. what is rightThese are just some...
In Smackdown vs Raw 2011 how do you lean the ladders on the rope?
Pick up the ladder, stand right next to the ropes, and press circle (ps3)/B (xbox 360).
How is the ice age vs stone age different?
It has lots of different things like they use different tools ,and they act different too
When is plants vs Zombies2 coming out?
plants vs zombies 2 is just like the xbox version because the game is different
When is plant vs zombies2 coming?
plants vs Zombies 2 is just like the xbox version because the game is different
