Want this question answered?
the recommendation for the differential housing cover bolts is 16 ft. lbs.
Absolutely. I have a 2000 7.3 diesel drw that has 3.73 rear end. There is a tag between 2 of the bolts on the rear cover, it should be stamped on that tag.
Front caliper mounting bracket bolts torque to 57ft-lbs Front caliper pin bolts torque to 27ft.lbs Rear Caliper mounting bracket bolts torque to 38ft-lbs Rear caliper pins torque to 15ft-lbs
Answering "What is the wheel bearing torque specs in ftlbs on a Ford 10.5 rear axle on a 2002 F350 Super Duty 4x4 non dually diesel?"
To engine and front cover.....18in. LBS step 1 Step 2.. oil pan to rear cover....106in. LBS.
There are five valve cover bolts (since this is an SOHC engine it's also called a cam cover); two longer bolts in the rear and three shorter bolts in the front. You will need to remove the spark plug wires and the wire harness located on the left, front of the cover, as well as a hose on the rear left corner to remove the cover. The bolts have a 10mm head. The bolts are tightened starting with the front, middle bolt, then back right, back left, front right, and front left. They are tightened to 86 in-lbs and it is very common to over-torque them and snap them off.
Under the vehicle, in the rear of the engine there are two bars on each side of the oil pan, remove them and then there is a cover that comes off the bottom of the bellhousing, remove that and you can get to the bolts one at a time.
Step 1 ( to engine and front cover) 18 Ft. LBS.Step 2 ( to rear cover) 106 inch LBS.Step 3 ( Bellhousing, converter cover and transmission bolts ) 37 FT. LBS.
30 - 35
"Snug" will work
what is the torque for the rear crankshaft cap and flywheel bolts on a ferguson tea.
Remove the bolts fastening the rear seat cushion (Figure 7.52).Remove the rear seat cushion assembly.Remove the screws and remove the side rear seat back (Figure 7.53).Remove the lower bolts fastening the rear seat back.Tightening torque - 17-26 NmFlip forward the rear seat back, remove the bolts and remove the back seat.Tightening torque - 17-26 Nm