Basically, 2 pieces of metal with a rubber boot in the middle that should be squishy (grease inside it) with zerk fittings on the ends.
lmc truck (www.lmctruck.com). there is a diagram for upper and lower ball joints for the front end.
It depends on the year, and whether it's 2WD or 4WD. I suggest entering your question again with the year. People have posted answers for specific year models. All Ford Rangers from 1993 to 1997 have "I-beam" front suspensions as opposed to the upper and lower control arms that most vehicles have. There is a detailed answer for replacing the upper and lower ball joints for '93 through '97 Ford Ranger ball joints at the question: "How do you change ball joints on 199X Ford Rangers?"
the pcm is located along the upper edge of the firewall in the engine compartment..
can you use a transmission from a 1993 ford ranger in a 2000 ford ranger?
how to i change a clutch in a 1993 ford ranger
How do you replace the CV joints on a 1993 Nissan Sentra XE?"
Grayson Jim Helms has: Played Chopper Pilot in "Walker, Texas Ranger" in 1993. Played Sanchez in "Walker, Texas Ranger" in 1993. Played Steve in "Walker, Texas Ranger" in 1993. Played Ranger Pilot Jim in "Walker, Texas Ranger" in 1993. Played Pilot in "Walker, Texas Ranger" in 1993. Played Ranger Pilot Chris in "Walker, Texas Ranger" in 1993. Played Pilot in "The Con" in 1998. Played Bartender in "Missionary Man" in 2007.
Ranger X happened in 1993.
Ranger X was created in 1993.
1993-1997 it is under the housing where the upper radiator hose attaches to the engine.1998-2004 it is under the housing where the lower radiator hose attaches to the engine.1993-1997 it is under the housing where the upper radiator hose attaches to the engine.1998-2004 it is under the housing where the lower radiator hose attaches to the engine.
1993 to 1997 body styles are the same. doors will fit
The engines in a 1993 Ford Ranger are fuel injected , so there is no carburetor