Car Batteries

What do battery connectors do?

567

Top Answer
User Avatar
Wiki User
Answered
2016-05-11 15:15:10
2016-05-11 15:15:10

Battery connectors are what connect batteries to devices so the device can get power from the battery. Electricity is the flow of electrons, and a battery has to have a way for the electrons to leave (negative wire) and return (positive wire). Thus the terminals on the battery are what do this, and battery connectors in a device or vehicle are what carries the electricity to the device or vehicle so it can be used.

For instance, they electrically connect the battery to a laptop to power the computer.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


Rusted connectors on a vehicle's battery could be the cause of a car that won't start. The process for cleaning these connectors can be detailed in full on wikiHow.


It is recommended that you change out the battery in the Pontiac Torrent every four years for optimal performance. To change the battery, simply loosen the connectors and remove the old battery. Insert the new battery, fully tighten the connectors and within minutes, you'll be back on the road.


remove the seat, place the battery into the holder, connect the drip tube, connect the battery connectors


Power connectors keep your electronics running! When the battery dies, you plug it in and it connects to your electric and charges.


When a car battery in connected to itself (i.e. You connect jumper cables onto a battery and then connect the other two connectors to each other), you create a continual circuit with the battery and nothing else. A similar effect is when you hold a 9 Volt battery to your tongue and you feel a small but continual "zap". Imagine this effect, but much greater. Sparks will appear when the connectors are first connected. Warning: Do not do this. This will damage your car battery. The only reason you should connect a car battery through jumper cables is to connect it to another car's battery in order to "jump" a car.


Red means that the battery charge level is low or that the alternator is not charging battery properly. Check alternator, voltage regulator, connectors.


If the voltage is the same, with suitable connectors, and it fits in the space, probably yes.


Does it crank over? Check the battery connections, check for any other loose connectors,



The battery is easy enough to change but rather expensive. Try removing the two battery connectors and clean and reinstall them securely first. These connectors conduct a lot of current so the must be in good condition and tight.


Wear safety goggles and disconnect battery terminals from battery. Remove serpentine belt, then remove all electric connectors and bolts securing alternator. Replace with new part and re-install all electric connectors and bolts securing it. Re-connect battery terminals and your done.


You have to find the bolts on the battery post connectors.. You have to loosen them with a tool that fits the bolts there and turn anticlockwise which will allow their removal


Unscrew the battery connectors, unhook the condensation tube, lift the battery out of the holder. Put the new battery into the holder and reconnect everything. It is always a good idea to disconnect the negative battery connection first and replace it last to prevent accidental shorting.


The following tips will help you troubleshoot your Samsung Gravity battery issues. Fully charge your battery to ensure that all your handset features work. Turn your handset off, remove the battery and check the back of the battery for a colored dot. A battery with a colored dot has sustained water damage and must be replaced. Dirty connectors can interfere with the electrical current. Clean the metal connectors with a cloth and reinstall the battery. Wait a few minutes before reinserting the battery. This will enable your handset to perform a hard reset and may correct hardware or electrical issues.


its beside the battery has 2 connectors that plug in to it the smaller one is the trans computer


water got into electrical connectors and or fuse box shorting them out



yes if one of the wires was getting an earth from the alternator cover or rubbing off the engine the battery light is really an alternator light warning you that the alternator is not charging the battery


1. turn iff your car engine 2. remove the battery terminal. AT FIRST HE BLACK THEN THE RED TERMINAL. 3. use a wrench to loosen up the plugs and then 4. unplug the battery terminals. 5. get the connectors and find a similar one from autozone or some places like this 6. do the same thing in a reverse manner.


I know its simple but make sure battery is good, if it is something else is going on, it could be there's a bit of corrosion on connectors where the battery goes


This battery is not located in the usual place (i.e., under the hood). It is located under the back seat. It also has acid gas vent hoses attached to it, which must be removed before the battery can be taken out. This battery has side terminal connectors.


To replace windshield washer bottle Remove 1 Battery 2 Battery tray 3 electrical connectors 4 Washer Tank


If the battey is dead it won't charge. But it sounds like the alternator is bad. If you're sure tha battery is good then it has to be alternator, wiring, connectors or switch.


To replace the battery cables on a 1999 Mercury Mountaineer, loosen the connectors at the terminals. After this, remove the other end of the cables and install new ones.


A battery snap is two metal studs on a clip that has a positive and a negative wire coming off it. The battery snap is pushed on to the connectors on a 9 volt dry cell battery. The cables can then be connected to an electrical DC device that is rated to use 9 volts.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.