Want this question answered?
On my '89 Tempo, heater controls are held into the dash kinda like how the radio is held in. Since I don't know of a tool to remove the heater controls like the one for the radio, I stuck something into each hole to hold back the clip. A bit of wiggling and I had it out.
this model does not have a heater control valve, it has a specail thermostat that controls flow.
Is the blower working? Could the heater core be "blown? If the controls are electronic, there could be a bad relay in them. It honestly sounds like a problem for the dealership will need to track down.
Sounds like the heater control valve. It could be the blend door actuator motor,which is located on top of the heater housing. this is what controls the fresh air flow through the heater.
There isn't a fuse for the engine block heater , it is like the heating element in an electric kettle , as long as it is plugged in and you are not using a timer or some other device that controls the electricity , then the block heater is on ( assuming that there isn't a break in the block heater cord , which has happened to me a couple of times , where I've had to put a new " male " end on the block heater cord ) or something wrong with the heating element
Ocean floor from the edge of the continental shelf to the continental rise
You need to replace the entire panel with all controls Stealership price is about 600.00 plus install or you can go to Ebay and find it for under 100.00 like I did
Snails like heat, but not too much. So don't keep it on the heater! P.S how would you like it if i put you on a heater and left you there ;)
Take out the "like" and just say Death is a heater. That's a metaphor. "Like" or "as" makes it a simile.
Need more info here. Not sure what a heater pump is.
Do a Google search " 1976 Lincoln Continental "
Its most likely your monovalve. It is the unit that controls the flow of hot coolant into your heater coil. Its like another little radiator that your inside fan blaws across. The mono valve has a diaphragm that often breaks and needs replacing. About $100 if you do it yourself.Performanceproducts.com offers one for $65.