0
Need more info here. Not sure what a heater pump is.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the heater control valve on a 2000 Chevy Blazer and what does it look like?
this model does not have a heater control valve, it has a specail thermostat that controls flow.
What does the heater control valve look like in a 88 Toyota supra turbo?
its right beside the wiper switch
Where is the heater valve on a 1988 Chevy truck?
The heater valve is in line in the heater hose from the top back of the 350 engine about half way to where it enters the firewall to connect to the heater core. The valve has a steel wire control cable connected to the top of the valve control lever. It has two hose connections, one in from the engine and one out to the firewall core entry point. Trace your heater hoses and look for the metal valve with the spiral covered control wire.
How does a water heater vacuum relief valve look like?
Please see link below.
Where is the heater control valve on a 1991 Ford Aerostar?
Look near or behind the alternator. The valve that controls flow of coolant to the heater core on my 1987 Aerostar is located on the left wall of the engine compartment. I imagine the 1991 is similar. Trace the heater hoses from the engine/water pump and you will find it.
How do you replace heater control valve in 2000 ford F150?
look right above the battery and you will find a TEE valve on a little black hose. mine has a blue valve on the tee pull it off and slide the other in
Where is the heater control valve on a 1995 Astro and how do you replace it?
I have a 94 Astro but the heater control valve should be in the same location. Look under the hood on the passenger side. There are two heater hoses behind the coolant reservoir and windshield washer reservoir. The hoses attach to the heater control valve. The valve has a round vacuum actuator on the side, and two more heater hoses leave the control valve and go into the heater core housing. Cost for the valve will probably be somewhere between $50 & $70 To replace it, remove the coolant reservoir and the windshield washer reservoir. Remember, or mark, the hoses for the washer if you have a rear washer. The electrical connections only go on one way. Remove the clamps securing the front heater hoses and remove the hoses from the valve. Remove the clamps holding the heater hoses coming off the back of the valve where they are attached to the heater core. These two hoses are factory attached to the valve and the new valve (from the dealer) comes with the hoses attached to the rear of the valve. The clamps are back in a small space behind the valve, rather hard to get to. We pulled the bracket with the three square relays situated above the hoses to allow easier access. Install in reverse order. Good luck.
Is it ok if I adjust the control valve on my water heater or should I have a repair man look at it?
It should be fine if you move it yourself. It should not mess anything up by you touching it, and not a repair man.
Where is the resistor for the heater and AC fan control located on a 2000 Pontiac Grand Prix and what does it look like?
Behind glove box
Why is my 1996 Lexus ls 400 heater not working?
most likely cause is the heater control valve under the hood on the passengers side near the firewall. Look at the control valve and cable for a crusty dry residue leaking from valve onto cable. If there are signs of a leak the fluid tends to travel down the cable causing it to seize. Once this happens the servo bends the cable on the inside of vehicle. It is very easy to replace the valve and cable, but make sure you tape the cables together to help feed the new one through.
Heater hose valve replacement on 1998 Ford Ranger what does it look like?
Follow the 2 small heater core hoses from the passenger side near the fan motor. About a foot down you will see a small black plastic device with a small gray vacuum hose connected to it. This is the heater control valve. Depending on your model it could have 2, 3, or 4 hoses connected to it. I just replaced mine for around $20. It took 15 minutes to replace. DO NOT WORK ON THIS ITEM WITH A HOT ENGINE!!!
Where is the Idle control valve on a 2005 Kia Rio?
Look in the back, behind the motor on the right side. It looks like a screw sticking out.
