I have a 94 Astro but the heater control valve should be in the same location. Look under the hood on the passenger side. There are two heater hoses behind the coolant reservoir and windshield washer reservoir. The hoses attach to the heater control valve. The valve has a round vacuum actuator on the side, and two more heater hoses leave the control valve and go into the heater core housing. Cost for the valve will probably be somewhere between $50 & $70 To replace it, remove the coolant reservoir and the windshield washer reservoir. Remember, or mark, the hoses for the washer if you have a rear washer. The electrical connections only go on one way. Remove the clamps securing the front heater hoses and remove the hoses from the valve. Remove the clamps holding the heater hoses coming off the back of the valve where they are attached to the heater core. These two hoses are factory attached to the valve and the new valve (from the dealer) comes with the hoses attached to the rear of the valve. The clamps are back in a small space behind the valve, rather hard to get to. We pulled the bracket with the three square relays situated above the hoses to allow easier access. Install in reverse order. Good luck.
Remove the heater control valve and replace it.
A 1999 Dodge Ram does not have a water control valve.
Replace the heater control valve motor, a dealer part, costs around $166.00.ish
It does not have a heater control valve.It does not have a heater control valve.
vacume line to the valve has broke off from manifold vac that goes to the switch
Where is the the heater control valve??
The heater control valve is mounted on the engine side of the heater and evaporator box which is located on the passenger side of the engine compartment. It will have at least three hoses connected to it and one vacuum line. It kind of hides underneath the a/c accumulator.
My 2004 ford explorer there isn't any vacum from the present heater control valve and the blower has been replace and the themostat has been replace and there is a clicking behind the a/c unit
where is the heater control valve
The heater control valve is used to shut off hot coolant from entering the core when the heater is in the off position. A heater control valve can be actuated by either a vacuum line or a cable from the vacuum heater control valve to the heater core. This hose should be warm; if not the heater control valve is stuck and needs to be replaced
How do u find a heater control valve on a 96 Ford e150 4.9
Where is the heater control valve on a 1994 Buick Regal