answersLogoWhite

0


Best Answer
User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What do you call the piece that hooks on to the throttle body air intake on a 96 trans am with a 5.7 l?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the part that connects in the tran that the speedo cable hooks into?

Depending on your car you have one of 2 things the speedo cable hooks to in the trans. It iether goes directly in to a gear in side the trans or hooks to a gear box which redirects a secound cable to the trans speedo gear. good luck Don


How put more hourse power in a trans am?

change out the intake, throttle body, exhaust, get a tuner like predator, switch to the slp ram air, and cut your egr valve.


Will a trans am air box fit on a v6 firebird?

You can make it fit but not without some modification. You see the V6 Fbody has an angled throttle body and intake, Trans Ams have a different style connection. I have seen it done before but with all the trouble you will go through I would not recommend it. A Cold Air Intake would be a suitable alternative.


What practices is not consistent with achieving a healthy diet intake eggs intake of nuts emphasis on trans fat emphasis on low fat milk?

emphasis on trans fat


Location of dodge ram 1998 5.2l throttle position sensor auto trans?

Located on the passenger side of throttle body housing


On a 350 with Edelbrock intake and carb if there is a t-shaped nipple coming out of intake behind the carburetor what hooks onto these three openings?

Those are for your vacuum lines.You will need rubber hose for them..If you have power brakes,One goes to the brake booster. One is for vaccuumm diaghram on auto trans and on is to vaccuum canister. unused ones can be plugged off.


What is involved in taking a throttle body 350 and making it carbureted if you have a 1984 Chevy 12T pickup with the TH350 auto trans HEI ignition with a carbureted 350 in it now that is bad?

just about the only thing you have to do is get a intake that is drilled for vortec heads or put a set of pre 87 heads on it. I just did one in a truck and the two center intake bolts on the throttle body motor go in straight and they go in on a angle on the older motor.


Where is the neutral safety switch located on a 97 mustang with a 3.8 automatic?

it is part of the trans range sensor. mounted on the right side of the trans. The shift lever hooks to it also


Where is the neutral safety switch ON A 2004 FORD CROWN VICTORIA located?

on the trans were shifting linkage hooks up


If antifreeze leaks from the transaxle seal of your 96 Chevy Lumina van how can you fix this problem yourself?

The antifreeze is not coming from your transaxle actually it is usually from your intake ,running down the trans case. This is a very common problem that 3.1,3.4 lt have is leaks at the intake.You have to replace your intake seals. But check under your throttle body ass. to make sure its the intake and not the heater hose connection that runs underthere.


Adjust idle speed on 1994 trans am?

the TPS (throttle position sensor) controls the idle.


2003 silver ado neutral safety switch?

It is on the side of the transmission were the shifter cable hooks to the trans. That will be the NS switch.