Want this question answered?
No. After mixing them, they settle into two separate layers (oil above the water) without any new substance formed.
Yes, it can be used for special uses. I want to know the process by which i can take salt pellets in fragrant oils and have the oil abbsorb -be infused throughout the salt pellet.
Fractional distillation.
No, lubricating oil does not dissolve in water. Because water is very polar and lubricating oil is nonpolar, it is not energetically favorable for oil to dissolve in water. The reasoning behind this is that water's strong hydrogen bonds must be broken in order for the oil to dissolve, and because only weaker bonds are formed in the process, it takes too much energy for this process to occur.
You probaby have a blown head gasket, cracked head or both. Try doing a compression test.
No, it is a physical process.
no oil and water do not mix
Yes
Oils and water are not miscibles.
Yes
very bad! change the oil
The primary emulsion is formed by mixing the entire amount of oil with the gum, adding the water required for the primary emulsion all at once and mixing vigorously until a thick and sticky emulsion results.
The primary emulsion is formed by mixing the entire amount of oil with the gum, adding the water required for the primary emulsion all at once and mixing vigorously until a thick and sticky emulsion results.
The primary emulsion is formed by mixing the entire amount of oil with the gum, adding the water required for the primary emulsion all at once and mixing vigorously until a thick and sticky emulsion results.
if you have have water mixing with the oil then your cylinder head gasket might need replaced if it is not overheating just give a good run, when the oil heats the water will evaperate
It is a physical change because the oil and the water do not change in chemical composition.
Change your oil cooler.