Start by checking all the lamps to make sure 1 is not blown that could be the cause. If not a lamp it will be the actual flasher unit which is located under the dashboard usually drivers side. You are looking for a cylinderical shaped unit silver in colour around 2 to21/2 inches long and 1" in diameter with a 2 pin plug in one end. Usually held in a spring bracket. If you get that out take it to an Auto parts shop and buy a new one ansd stick it back in. Should do the trick
need to know what wire go were for a 94 Mazda protege MAF sensor
well it depends on your year, and if it is an lx dx, or es. The lx and dx for 1995-1998 protege's are 13" stock. The es i believe is 14". If you are looking to put new rims on the protege, the biggest ive seen go on a protege was about 17" but that might even be close to rubbing.
go look on youtube its all there
It does the link between the manifold and the catalyser.
power steering fluid resivour
bbb
1157A
Go outside, look under the car, and count them.
Remove the power steering belt first then the alternator belt will go on.
I have a Mazda protege 1996 that is parked because it will not go into drive but the engine starts?
in most cars, when your car dont go over about 30mph, its a trans problem.
if your horn wont go off its a short to power or faulty conector