the steering wheel is in a bind and holding the locking pin to tight try turning the wheel and the key at the same time
Disabling the keyless ignition security lock on a 2007 Saturn can be done by programming the security locks. Turn the ignition to run, without actually starting the engine, and press the unlock switch for eight seconds.
ingnition switch locks up on 2003 Ford Mustang and only way car will start is if you can turn steering wheel back and forth to get ignition key to turn
I have a 2001 Saturn sc2 and i was reading the driver's manual about this because I had trouble too., It seems as though the car as steering lock where if if turn your steering wheel a certain way, then it locks the key from being turned. All you have to do is turn the steering wheel a little and then turn the key. It should work!! Janie
Your ignition also locks your steering and at times you need to move the steering wheel a little and at the same turn your ignition key. Then you should be able to turn the key and start the engine. Hal
turn the key in the ignition
To disable it or put it on again . Turn ignition key on and off 4 times
Try turning your steering wheel side to side. It sometimes locks up and won't let you turn ur key
I believe you hold the trip odometer button while turning on the ignition.
Try this: Turn the ignition to RUN (do not start), press the unlock button on the keyless remote, ignition OFF. Repeat 2x. Turn the ignition to RUN, press the unlock button on the keyless remote twice, the power locks should cycle to indicate successful programming. Turn the ignition OFF and test remote.
Some times you can just jiggle the steering wheel back and forth as your try the ingition. The problem is common with LS2 Saturn steering locks; the steering lock must be engaged for this to work. If it isn't, use the above method to get it to lock.Once the steering lock is engaged you turn the steering wheel hard to the right as you turn the key in the ignition. This will usually free the switch up. Saturn keys are made of a very soft material and wear down significantly over time. USE CAUTION NOT TO USE SO MUCH FORCE ON THE KEY or it could snap off in the ignition. The brute strength should be applied to the steering wheel, not the key!
Push the key into the ignition. To remove, push in, then turn towards you to remove the key. I do not know how to remove and replace the whole ignition assembly in case that was your real question.
Turn igniton to on position and put odometer in trip mode, turn off ignition. Hold trip button in and hold it in as you turn ignition to on position, it will flash Turn off ignition. Maintenance light should go and stay off