A buffer is merely a temporary storage used in conjunction with computation.
micro controller contain system on chip memory, timers,counters where as a micro processor doesn't contain all these
The 8086/8088 instruction queue is a buffer that holds opcode bytes that have been prefetched by the bus interface unit. This speeds up operations of the processor by helping to reduce fetch latency, i.e. to improve the probability that an opcode byte fetched by the processor is already available.
In a microprogrammed processor, the hardware doesn't directly execute the instructions in the ISA  The hardware executes very simple micro-operations that are used to implement the instructions  Each instruction specifies a sequence of micro-operations that are used to implement the instructions
It's the model number.
There are Celeron dual core processors today. However, just because you have Celeron processor, it does not mean your Celeron processor is a dual core processor. The easiest way to tell is to look at the Intel sticker on your computer. If it says "Dual Core," then it is dual core. If it does NOT say "Dual Core," then it is not dual core.
micro processor card
what is name of latest micro processor in computer hardware in india
micro controller contain system on chip memory, timers,counters where as a micro processor doesn't contain all these
Because the printed circuits are so small that you need a microscope to see them.
Ram
It is integrated with Processor itself. Also called Cache Memory.
no answer
Micro-Processor programming model refers to the Micro-Processor system as seen by a programmer. It involves the following: The Instruction Set - The Micro-Processor internal Registers - The way Micro-Processor accesses the memory (Addressing - Mode): Micro-Processor 'Fetches' (reads) an instruction from memory, 'Decodes' (interprets) the instruction, and then 'Executes' (carries out the task) the instruction. It repeats the cycle for next instruction. By Fijabi Isaac M. Tech Computer Sc.
Gary Boone
By using buffer along with micro-controller, it is possible to reduce the effect of 'back EMF' or 'Spiking Effect'. The capacity of any micro-controller is to sink or source current up to 25mA and its ports gets damaged if it is more. So buffer protects ports of micro-controller getting damaged. And it is possible to get appropriate data trans-receiving by using buffer in micro-controller.Sachin Joshi
It is called a micro-processor......a processor on a single chip
the first name of the micro processor Motorola M6800