It is 10 degrees South and 76 degrees West, as stated in the question!
-10 degrees Celsius = 14 degrees Fahrenheit.
That's near Maracaibo.
10 degrees Celsius because that is 10 degrees warmer than the freezing temperature (which is 0 degrees Celsius) where as Fahrenheit would be 23 degrees colder than the freezing temperature (which is 32 degrees Fahrenheit)
-12 degrees C is lower than -10 degrees C
Should be 8 to 10 degrees before TDC
10 degrees before TDC
depending on the year 72 and prior 4 to 6 degrees before tdc after 10 degrees before tdc
10 degrees before TDC
The timing will be 8 degrees before top dead center i believe although my 86 2.8 says it is 10 degrees before tdc
10 degrees tdc
8 to 10 degrees below Top Dead Center yes, true but most folks understand "before" TDC better.... I know what you mean..when piston is below TDC in compresion stroke
Between 8 and 12 degrees before TDC... My 454 is set at 10 degrees BTDC and it runs great.
TDC is 0 degrees TDC, not 10 degrees BTDC which is before top dead center. ATDC is after top dead center. Both of these in relation to piston height are "below top dead center".
my service manual says 10 degrees before tdc on auto models with ac off idle @750
i would start with 10 degrees before TDC and test drive to make sure there is no ping when under load
With 99 octane gas: Single carb 5 deg Before TDC / Three 2brl carbs 10 deg before TDCWith 98 octane gas: Single carb 2,5 deg Before TDC / Three 2brl carbs 7,5 deg before TDC