on ebay search for NEW STARTER CHEVY 4.3L S10 BLAZER, C SERIES TRUCK 99 00 01 02 03 04 & ASTRO VAN this gives you an image.
sounds like the ignition module is failing in the heat.
If it is like my '86 Samurai there is no starter relay. It uses a starter solenoid on the top of the starter to pass battery to starter motor when the solenoid is activated via the key switch.
Sounds like a starter issue. Bad wire to the starter could cause it.
I'm having the same problem with a 1987 ford E350 with a 460 auto trans. I just replaced the engine with a used one from a 1988 ford F250 with a 460 4wd auto trans. and now the starter won't release from the flywheel and it is making a bad grinding sound. I searched around on the net a little bit and it looks like all the 460 from 84-91 list the same part numbers for the starter, and flywheel. my old starter had some movement in the shaft and sounded like it was grinding a little so, I replaced the it with a new one from Auto Zone. And it still dose the same thing. There is no adjustments to be made with a ford starter like a GM starer. It should just bolt right up and that's it. So now I'm not sure what to do. I don't work on fords that much so if you have any ideas please let me know.
Like a cylinder with a smaller cylinder on to of it. It will be sittind sideways
It is on the passenger side underneath the exhaust manifold and likely has a heat shield around it so, it may not look like starter.
Pretty much the same as any other Chevy starter since 1955. Passenger side, below the exhaust manifold and going into the transmission. 7-8 inches long, 4 inch diameter with a hump on the side.
They are lined up like this on my 1995 Chevy blazer 4.3 L, V6 1,6,5,4,3,2
You can get your code at www.delcolockcodes.com It'll cost you $6.99 but from the reviews it seems like they're really quick and honest.
One can buy Chevy Blazer part son Houston when one goes to the site Chevy+in+Houston. This site offers used Chevy as well as Chevy Blazer parts. Or one could go online to sites like Auto Trader.
tighten the nut from the starter to the solenoid
i like an axhaust diagram for a 1999 chevy venture
its under the glove department. and if its like my blazer under the little shelf like thing under the glove department.
On top of the starter - looks like a juice can
I would like to know if my 2002 chevy blazer with a stock 4.3 vortec pull 2000 lbs ?
spagettie
It looks like color coded spaghetti.