answersLogoWhite

0

on ebay search for NEW STARTER CHEVY 4.3L S10 BLAZER, C SERIES TRUCK 99 00 01 02 03 04 & ASTRO VAN this gives you an image.

User Avatar

Wiki User

10y ago

What else can I help you with?

Continue Learning about Art & Architecture

What is wrong with a Chevy Blazer that dies when it is hot outside but starts back up after a minute or two and runs great when it is not hot outside?

sounds like the ignition module is failing in the heat.


Sj413 starter relay where is it?

If it is like my '86 Samurai there is no starter relay. It uses a starter solenoid on the top of the starter to pass battery to starter motor when the solenoid is activated via the key switch.


Why Truck will not crank but battery juice is good?

Sounds like a starter issue. Bad wire to the starter could cause it.


Your 1993 s10 Chevy blazer is dumping gas into the oil and it wont start what is causing this problem?

sound like you have a 4.3 vortec with a bad spider. it is multiported so inside the plentum of the intake, there is your spider, they go bad and fill up your intake with fuel, then dump it down the valley of the engine.


1995 Ford F-150 Starter not disengaging?

I'm having the same problem with a 1987 ford E350 with a 460 auto trans. I just replaced the engine with a used one from a 1988 ford F250 with a 460 4wd auto trans. and now the starter won't release from the flywheel and it is making a bad grinding sound. I searched around on the net a little bit and it looks like all the 460 from 84-91 list the same part numbers for the starter, and flywheel. my old starter had some movement in the shaft and sounded like it was grinding a little so, I replaced the it with a new one from Auto Zone. And it still dose the same thing. There is no adjustments to be made with a ford starter like a GM starer. It should just bolt right up and that's it. So now I'm not sure what to do. I don't work on fords that much so if you have any ideas please let me know.

Related Questions

What does a starter look like on a 1996 Chevy blazer?

Pretty much the same as any other Chevy starter since 1955. Passenger side, below the exhaust manifold and going into the transmission. 7-8 inches long, 4 inch diameter with a hump on the side.


Starter location for a Chevy surburban 1999?

It is on the passenger side underneath the exhaust manifold and likely has a heat shield around it so, it may not look like starter.


What is the pattern for spark plugs on Chevy s10 blazer?

They are lined up like this on my 1995 Chevy blazer 4.3 L, V6 1,6,5,4,3,2


Where can one buy Chevy Blazer parts in Houston?

One can buy Chevy Blazer part son Houston when one goes to the site Chevy+in+Houston. This site offers used Chevy as well as Chevy Blazer parts. Or one could go online to sites like Auto Trader.


How do you get free delco radio code for 1999 Chevy blazer?

You can get your code at www.delcolockcodes.com It'll cost you $6.99 but from the reviews it seems like they're really quick and honest.


1999 Chevy Tahoe limited and replace ignition switch and safety neutral switch and vehicle will not crank like it was in D and also replaced and checked starter relay and crank fuse tested starter?

tighten the nut from the starter to the solenoid


Would like an exhaust diagram for a 1999 Chevy Venture?

i like an axhaust diagram for a 1999 chevy venture


Where is the blower motor on a 94 Chevy Blazer?

its under the glove department. and if its like my blazer under the little shelf like thing under the glove department.


Where's the starter relay on 1989 Chevy Silverado?

On top of the starter - looks like a juice can


Could a stock 2002 Chevy blazer vortec 4.3 tow 2000 pounds?

I would like to know if my 2002 chevy blazer with a stock 4.3 vortec pull 2000 lbs ?


What does the wiring look like on a 1993 Chevy blazer under the dash?

It looks like color coded spaghetti.


What does the neutral safety switch look like on a 2000 Chevy s10 blazer?

JEFF TAYLOR