Modern automobiles have brake pad thickness sensors. My 2004 Forester has one on the rear and one on the front. The sensors are mounted on one brake pad each. When the brake pad wears down to a predetermined thickness the brake rotor wears the coating off of the sensor and provides the contact surface so that the connection is made between the two wires ( on some cars) or just provides ground on others. Now the brake indicator light comes on. The thickness of the pad where this happens is set so that you have some time to react before the metal backing plate of the brake pad comes into contact with the brake rotor and destroys it.
The battery light means that a low voltage condition exists at the battery. Not in the battery, the light does not come on if your battery fails, it comes on because your altenator is not putting out enough voltage to power the vehicle. This could be altenator failure on the belt driving it has a problem. Loose or even broken. When the voltage falls below 7 volts your ignition system will fail and the engine will stop running not to mention that the electric starter won't function. Hope this helps.
It is important to pay attention to the warning lights on the dashboard. The Battery warning light turns on when there the battery of a car is having a problem.
The check engine and other dash warning lights can be reset by disconnecting the vehicles battery for more then 5 minutes. If warning light continues after reconnecting battery then there is still a problem.
When driving at night with the headlights on, the radio and other display lights automatically dim. The bright button brightens those lights if you have trouble seeing them.
Normally this is caused by a defective brake light switch or one that is out of adjustment.
broken belt
Most of the light on the dashboard are Warning Lights; different warning lights that might flash up on the dashboard. Some of the more common warning lights are shown below. 1 = Oil pressure warning light 2 = Battery charge warning light 3 = Brake system warning light 4 = Engine warning light
hi, behind the coin tray on the drivers side, you have to pull it out
The 1998 VW beetle is equipped with several dashboard warning lights. The warning lights include; high water temperature, wall oil pressure, ABS braking system failure, and low battery.
on most vehicles you can reset warning lights by simply unconnected a battery cable
Some Subarus have a switch on the top of the steering column that turns on the parking lights. Hopefully this is the problem and would be an easy fix. Daniel
Can't say for sure on the 2007, but my 2000 has a rocker switch at the top of the steering column to turn the parking lights on when the key is off.
Unbolt the battery for at least ten seconds. Mechanic, Why are the parking lights flashing after new battery installation?