0
A bad engine rod is an engine rod that has misbeheaved.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What does it mean when there is a knocking noise from the engine when you let off the gas?
A bad connecting rod bearing can do this
Why does your engine knock when you step on the gas?
Probably a bad rod bearing
What is the cause of a loud knocking sound in engine compartment?
Bad bearing or rod
What are signs of a bad push rod?
A bad push rod will not against the engine block. This will create a very loud noise that will come from the bottom of the vehicle. The vehicle should not be used when experiencing this.
What would cause a continuous knocking or clicking in the lower part of the engine?
A bad rod bearing
What does it mean when your engine has a knocking noise?
When your engine has a knocking noise, it could mean that a rod has been thrown. It could also mean you are low on oil.
What causes a bad push rod in a 84 Chevy 350 engine?
It is probably a broken valve spring.
What causes a clicking noise when alcerating?
your lifters are bad at least 1 of them or on a more serious note no oil in engine bad oil pump bad oil sending unit bent push rod blown engine
I just found out it is a bad rod in the engine I am going to check it out tomorrow. Have a few ideas about it. Guy is selling for 400 dollars would like to know if this is even going to be woth it?
First make sure you check that you have the proper oil level,it sounds like it is either a bad lifter or bent pushrod,or worst case a piston rod knock which would mean tearing the whole engine apart
Rod knock noise but rods and bearings are fine?
did you disassemble the engine to determine the rod condition? some harmonic balancers will make a knocking sound when they go bad
Can bad gas cause a push rod to bent?
NO it will not. Over revving engine, Rocker are adjusted to tight, Bad lifter. These are some common causes of that.
Is the tire rod connected to the engine?
There is no such thing as "tire rod" -You very likely mean 'TIE ROD' , these two adjustable rods connect the axle spindles with the steering rack.
