Want this question answered?
crank shaft sensor or(ckp) is look like a simple sensor.its color is black.its lenth is two inches.GILL G
look at the front (with the pulleys) of th engine
The crank shaft sensor is located on the bottom portion of the timing cover to the left of the crank pulley. Look for two wire harnesses and remove them along with the bolt.
The crank shaft sensor is on the bell housing of the trans, buy a new one and look for the plug end that looks alike. also if u are looking for the cam positioning sensor it is on the left side of the engine coming out of the valve cover.
Check Autozone.com or another such sight They might have a picture. They did for the same part for my 91 lesabre. (Which may very well be the exact same part)
Under the front of the right cylinder head. If you look up from underneath you can see the three wire connecter. ************please note that this answer is wrong...this is the location of the CRANK SHAFT SENSOR****************
bad crank shaft position sensor
What you look into what year what type of car you have get a owner's manual and look it up
There is only one crank sensor fitted, you may also have a cam sensor. the crank sensor is located either around the bellhousing or around the front crank pulley. It either has 2 or 3 wires. It picks the signal off the revolving crank so look for a sensor in the block near flywheel.
Hi # The crank sensor is located in the center above the harmonic balancer on the EF motor. # Mine has 2 white wires attached to a plastic connection which plugs into the crank sensor. Hope this helps. Sam
Start by pulling the cover on the bottom of vehicle. remove cover on starter and if you look at an angle towards the driver side up and in you will see the crank sensor. 10mm open end wrench will remove the bolt. trace plug to top driver side.
I am wondering the same thing; on 2.4l Go to Autozone.com look up your car, and it will tell you if the store closest to you has the part, and give you intructions on how to fix it.